Dot-Spot Light bollard twist Assembly And Operating Instructions

Assembly and operating instructions
Light bollard twist
1. General information and intended use
Please read these instructions carefully before installing / commissioning the luminaire and keep them! If you pass this luminaire
on to third parties, please also include these instructions. This product is a high-quality luminaire. It is used for lighting purposes
and must not be changed or modified. Installation and commissioning may only be carried out by qualified specialists. If these
instructions are not adhered to, correct function may be restricted, or the luminaire may be damaged. In this case we do not
accept any liability.
2. Delivery / scope of delivery
Upon receipt, please check that the goods are complete and undamaged. The delivery includes the light bollard with 2 mounted
individual spotlights, connection cable and an Allen key (2mm) to adjust the spots to each other and to attach them to the
mounting adapter or mounting flange.
For permanent installation, a mounting adapter, mounting flange and ground screw are available separately, depending on the
surface, they are not included in the scope of delivery of the luminaire.
3. Technical specifications
Operating voltage:
Power:
Beam angle:
Luminous colours:
Connection cable:
CRI:
Protection class:
Temperature range:
Light source:
Casing:
With open end connection cable:
Wire color red
Wire color black
Wire color blue
Attention: If the lamp is used without a dimmer, the blue line (S-PWM) must also be connected to ground -
otherwise the lamps will remain off.
dot-spot GmbH & Co. KG, 90592 Schwarzenbruck, Tel.: +49 (0) 9128/722217-0, Fax: -9,
Thank you for choosing this high-quality dot-spot product!
12-24 V DC with open end connection cable
24 V DC with M12 plug on dot-spot Multibox
2 x 3 W dimmable
6° (swivelling)
2700K, 3000K, 4000K
5 m open end or with a low-voltage plug M12
>80
IP 67
- 25 ° C - +50 ° C
not changeable, high performance brand
LED, integrated driver electronics /
Lights V4A stainless steel; hardened glass pane 4 mm /
V2A stainless steel bollard
Cable assignment with M12 connector system:
Pin 1 / brown
Pin 2 / white
Pin 3 / blue
Pin 4 / black
Pin 5 / green / yellow (grey)
+ 12 - 24V DC
- ground
S-PWM
+ 24V DC
+ 24V DC
S-PWM
- ground
- ground
www.dot-spot.de 11/20
page1 from5 pages