Download Print this page

Technical Data - Morphy Richards 36 RCSS Manual

Oven toaster griller

Advertisement

Follow the steps as under:
Ÿ
Hold the rotisserie tong with both hands.
Ÿ
Place the tong rods below the rotisserie rod
notches, provided at the extreme ends. Lift
up the left end of the rotisserie rod slightly.
Ÿ
Push the rotisserie rod towards left so that it
comes out of the socket.
Ÿ
Now lift the right end of the rotisserie rod.
Ÿ
Balance the tong with both hands along
with the food item and rotisserie rod while
removing out the same.
NOTE: The recipes given in the recipe section
are meant as a guideline. The timings and
temperatures given with the recipes may vary
to a certain extent depending on voltage
variations, ingredients used and ambient
conditions.
General cleaning and care:
1. After use and before cleaning, switch-off
the OTG, remove the power plug from the
socket and wait for the OTG to cool.
2. Wipe the glass door and the inner cavity of
the OTG with a moist cloth. Wipe again with
a dry cloth.
3. If any food particle or liquid has spilled,
clean it with a damp cloth and let the
interior dry thoroughly.
4. Never use metal polish or coarse scouring
agents for cleaning.
5. Do not scrub the surface of the cooking
tray with any hard or abrasive material,
while cleaning. Use a sponge or nylon
scrubber to clean the surface of the
cooking tray. To clean the stubborn food
particles on the cooking tray, make a thick
paste of normal washing powder using
little water and apply on the surface. Keep it
for a while, scrub with sponge and wash.
6. Removable wire rack, baking tray, crumb
t r a y c a n b e w a s h e d a s n o r m a l
kitchenware.
Repairs:
Electrical appliances must only be repaired by
authorized specialists. Because damages can
occur by non-authorized repairs, in the case of
a repair, contact Morphy Richards
center.

Technical Data:

Power Supply
: 230V, AC 50Hz
Wattage
: 1500W
6
service

Advertisement

loading
Need help?

Need help?

Do you have a question about the 36 RCSS and is the answer not in the manual?