1. Manuals
  2. Brands
  3. Prizelawn Manuals
  4. Spreader
  5. CBR IV
  6. Owner's manual

Prizelawn CBRIV Owner's Manual

Commercial broadcast spreader
Hide thumbs Also See for CBRIV:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

COMMERCIAL BROADCAST SPREADER
COMMERCIAL BROADCAST SPREADER
Model:
Model:
Prizelawn
Prizelawn
CBRIV
CBRIVSS
Owner's Manual
Owner's Manual
® ®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CBRIV and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Prizelawn CBRIV

Summary of Contents for Prizelawn CBRIV

  • Page 1 Prizelawn Prizelawn ® ® COMMERCIAL BROADCAST SPREADER COMMERCIAL BROADCAST SPREADER Model: CBRIV Model: CBRIVSS Owner’s Manual Owner’s Manual...
  • Page 2 ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS Spring Clip Remove the spreader and components from carton and place hopper up-side down on a padded surface as shown. Slide drive and free wheel onto axle as shown with the longer portion of wheel hub facing the frame. Both wheels are identical to ease assembly.

  • Page 3: Operation

    ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS Install control rod to handle lever with a 1/4” dia. clevis pin. Thread (1) 5/16” hex nut onto the control rod until it is roughly in the middle of the threaded area. Slide the end of the control rod through the L-Bracket making sure there no tension between the hex nut and the L-Bracket.
  • Page 4 PATTERN ADJUSTMENT PATTERN ADJUSTMENT Normal spreading of materials requires no adjustment (factory setting “A”) unless stated on the package. In those cases where the spread pattern has shifted, the pattern can be adjusted left and right by loosening the two knobs on the discharge chute and moving the chute closer or farther away from the impeller.

  • Page 5: Application Rate

    Weigh remaining material left in hopper and adjust rate setting as required. Repeat test until application rate is correct. RATE SETTING CONVERSION RATE SETTING CONVERSION The following provides approximate Prizelawn settings for those units /CBR IVSS ®...

  • Page 6: Calibration Instructions

    CALIBRATION INSTRUCTIONS CALIBRATION INSTRUCTIONS The Prizelawn was factory calibrated, however calibration should be /CBR ® IVSS checked occasionally to assure optimum performance. 1. Pull the on/off lever to the “OFF” position. 3. Loosen the rate control knob and slide the rate Set the rate control plate to setting “B”.

  • Page 7: Parts List

    PARTS LIST PARTS LIST for for CBR & & IV IV IVSS IVSS Description CBR IV CBR IVSS Description CBR IV CBR IVSS Hopper 60454 Drive Wheel & Free Wheel P790120W Discharge Chute & Shut- 2 & 4 P15144-04 Impeller Shaft P15641 Off Plate Guides* Pinion Gear...

  • Page 8: Optional Accessories

    OPTIONAL ACCESSORIES OPTIONAL ACCESSORIES & & iv iv ivss ivss P15681 Operation The deflector can be placed in two positions. The ON position (down) or the OFF position (up). To operate, simply rotate the deflector plate downward to the ON position using the kick plate. The spring will automatically pull the plate down and hold it.

This manual is also suitable for:

Cbrivss

Table of Contents