PRYME PRYMEBLU BT-537 User Manual

Federal Communication Commission Interference Statement
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
To maintain compliance with FCC RF exposure compliance requirements, please avoid direct contact to
the transmitting antenna during transmitting.
RF Exposure Warning!
Please keep product 20cm away from your
body or bystander during the radio operation.
The typical handheld two-way radios were
certified under mobile usage condition
(i.e. keep 20cm away from the user body)
and use of such radio closer than 20cm may
exceed the US RF exposure limit
and shall be avoided.
version 1.0 June 2024
Controls and Connection
Multi-Function Talk Switch / Status LED
Used to place the PRYMEBLU Radio Adapter in pairing
mode. The LED flashes messages that let the user know
the current status of the PRYMEBLU Radio Adapter.
Once paired with an audio accessory, this switch is used
to activate the Push-To-Talk function of the two-way radio.
911 Mariner St., Brea, CA 92821
PH: 714.257.0300 FAX: 714.257.0600
TOLL FREE: 800.666.2654
WWW.PRYME.COM
Radio Connector
This port connects the
Radio AdapterAdapter
to a compatible
two-way radio.
3
PRYMEBLU BT-537 USER'S GUIDE
®
For Harris Radios with MULTI-PIN Accessory Connectors
The PRYMEBLU Adapter allows you to use a compatible wireless
headset or other audio accessory with your two-way radio.
Bluetooth Adapter
Applicable Models:
BT-537
Made in Taiwan
FCC ID: N2E-BT533
PRYME® and PRYMEBLU® are trademarks owned by PRYME Radio Products,
Brea CA. All other product or service names are the property of their respective owners.
© 2024 PRYME Radio Products, Brea CA. All Rights Reserved
QUICK START
1. Connect the PRYMEBLU Radio Adapter to a compatible two-way radio.
2. Pair the PRYMEBLU Radio Adapter with a compatible wireless audio accessory.
3. Test and use.
Connecting the Adapter to Radio
STEP ONE: Connecting to Two-Way Radio
To connect your PRYMEBLU Radio Adapter to a two-way radio, follow these steps:
• Always turn off your two-way radio before connecting the PRYMEBLU Radio Adapter.
• Attach the PRYMEBLU Radio Adapter into the speaker-microphone / audio accessory jack of
your two-way radio.
• Tighten the retaining screw to ensure that the PRYMEBLU Radio Adapter remains attached
to the radio
• Turn on your two-way radio. Because no wireless audio accessory will yet be paired to
the PRYMEBLU Radio Adapter, received signals should be muted.
• The Talk button on the PRYMEBLU Radio Adapter will function as a Push-to-Talk button.
However the internal microphone in your portable radio will be disabled as long as the
PRYMEBLU Radio Adapter is attached. Mic audio will be muted* until a wireless audio accessory
is successfully paired to the adapter.
2
4