Datenhandling Mit Topterm; Setting Of Port - Topex 7100 Series User Manual

10

Datenhandling mit TopTerm

Warning!
Exclusively authorized stuff, trained by topex GmbH and with the required qualifi-
cations, may carry out the data processing with TopTerm.
Improperly made changes on the control unit might result in faults or
damages to the labelling system and in injuries for the operator.
The program TopTerm has been extended by the menu item „Topex7200".
Here you find submenus for the file transfer, change of setup, firmware download
as well as PLC programming.
Information!
For this function the service interface LAN2 or the serial interface COM1 of
the control unit is used. The baud rate in TopTerm must be set to 57600.
10.1

Setting of port

In order to use the TopTerm program for downloading files you have to use the
COM1- interface of the control unit with the adjustments 57600 Baud, 8 Data bits,
No Parity, 1 Stop bit and No Protocol
It might be necessary to reselect under „file"the function „SR-Terminal".
topex7100
Datenhandling mit TopTerm 10-1