Related Manuals for PRETUL DIMI-20P
Summary of Contents for PRETUL DIMI-20P
- Page 1 Manual Cordless impact screwdriver 6.5 mm 20 V 1/4” Bit holder Applies for: Code Model 28269 DIMI-20P DIMI-20P LITHIUM-ION Read this manual thoroughly CAUTION before using the tool.
-
Page 2: Table Of Contents
Contents CAUTION Technical data Power requirements To gain the best performance of General safety warnings the tool, extend its lifespan, for electric tools claim the warranty if necessary, and avoid serious risks or Safety warnings for the use of injuries, it is essential to read cordless impact screwdrivers this manual in its entirety before using the tool. -
Page 3: Technical Data
Technical data DIMI-20P Code 28269 Description Cordless impact screwdriver Bit holder 1/4” Voltage 20 V Variable speed 0 RPM – 2 200 RPM Strokes per minute 0 beats/min – 3 000 beats/min (BPM) Rotation forward - reverse IP rating IP 20... -
Page 4: For Electric Tools
General security warnings for electric tools WARNING. Read all safety warnings and all instructions listed This allows better control of the tool in unexpected situations. below carefully. Failure to follow any of them may result in electric Dress appropriately. Do not wear loose clothing or jewelry. shock, fire, and/or serious injury. - Page 5 Security warnings for the use of cordless impact screwdrivers Hold the power tool by the insulated gripping surfaces when performing an operation where the fastener may meet hidden wires or its own power cable. ENGLISH...
-
Page 6: Parts
Parts Bit holder collar Bit holder light Reversible mode and lock Non-slip grid selector Battery charger Handle Battery terminals Switch Battery release button Wrist strap LITHIUM-ION Battery indicator light Belt clip Battery Start up Battery charge • Connect the charger plug to a 127 V~ outlet (the green light on the charge indicator will turn on). -
Page 7: Start Up
Start up Considerations for battery use The battery is shipped in a DISCHARGED state by default. It is necessary to charge it for approximately 1 hour and 30 minutes before use. The normal charging temperature range is from 0 °C to 45 °C Charging is automatically suspended outside this range until it reaches the correct temperature. - Page 8 Start up Rotation direction • To screw, release the switch and press the rotation direction button on the side where the marks point to the bit holder collar. • To reverse and unscrew, press it on the opposite side. • The tool switch locks if the rotation direction button is in the middle position.
-
Page 9: Troubleshooting
Troubleshooting Problem Cause Corrective action The tool loses • Low battery. • Charge the battery. efficiency. The trigger cannot • The rotation direction button is in the • Move the rotation direction button to be pressed. lock position. forward or reverse position. The trigger can be •... -
Page 10: Notes
Notes ENGLISH LITHIUM-ION... -
Page 11: Authorized Service Centers
Authorized service centers ENGLISH... -
Page 12: Warranty Policy
Model Brand 28269 DIMI-20P Warranty. Duration: 1 year. Coverage: parts, components and workmanship against manufacturing or operating defects, except if used under conditions other than normal; when it was not operated in accordance with the instructive; was altered or repaired by personnel not authorized by TRUPER. To make the warranty valid, present the product, stamped policy or invoice or receipt or voucher, in the establishment where you bought it or in Corregidora 35, Centro, Cuauhtémoc, CDMX, 06060, where you can also purchase...
Need help?
Do you have a question about the DIMI-20P and is the answer not in the manual?
Questions and answers