1. Manuals
  2. Brands
  3. RW Manuals
  4. Recording Equipment
  5. nQuencer
  6. Manual

RW nQuencer Manual

Hide thumbs Also See for nQuencer:
Table of Contents

Advertisement

Quick Links

Download this manual
nQuencer
manual
random works

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the nQuencer and is the answer not in the manual?

Questions and answers

Related Manuals for RW nQuencer

Summary of Contents for RW nQuencer

  • Page 1 works...

  • Page 2: Table Of Contents

    Contents Overview Installation Settings Fader 1 - Mode Fader 2 - Sequence Direction Fader 3 - Probability Fader 4 - Output Voltage Range Fader 5 - Fader Behaviour Fader 6 - Gate Length Fader 7 - Alternative Reset Input...

  • Page 3: Overview

    16n faderbank into a step sequencer. When the nQuencer module receives a trigger at the Clock input it reads the state of the first 16n faderbank fader and outputs a corresponding voltage at Output 1. At the next clock signal it will read the second fader and so on until it reaches the end and loops back to the start.

  • Page 4: Settings

    CV output does not change and no gate is output. Fader 4 - Output Voltage Range The voltage output by nQuencer when the fader is at the top - 1v, 2v, 3v or 4v. Transpose mode adds up to 1v to this.

  • Page 5: Fader 5 - Fader Behaviour

    Fader 5 - Fader Behaviour Changes the behaviour of the sequence when a fader is at the bottom. 1. Note Off, Variable Length ○ Fader at the bottom doesn’t generate a gate (in modes that output a gate) ○...

  • Page 6: Configuration File

    ‘nquencer.txt’. Edit the text file and save it to make changes, then eject the device on your computer or power off and on your eurorack system to load the changes.

  • Page 7: I2C Output

    ● The default i2c address for the Disting EX is 0x31 but you can check/change the value in the settings ● nQuencer sends 0x51 pitch messages and 0x52 / 0x53 note on / off messages to channel 1 (and channel 2 for the second sequence in Two Eights mode) ●...

  • Page 8: Updating Firmware

    If you are getting unexpected gates output when faders are at the bottom, you may need to configure the fader minimum value. 1. Patch your nQuencer module so that it has a clock, the outputs are being used and it is connected to your 16n faderbank 2.

Table of Contents