SkylinkHome HB-318 Quick Manual

QUICK GUIDE
CARHOME BUTTON REMOTE
Model: HB-318
What's in the Bag
2 CarHome Button Remote
(Battery inside)
How to pair and control with opener

Press the setting button on the opener
device.

The segment LED on the opener
device will display P

Press the or button on the
remote.
How to set up in your car

Determine the installation location
(can be placed anywhere in your vehicle).

Attach one side of the 3M tape to the
backside of Carhome Button Remote.
The backside of the Remote
Model/Modèle:
HB-318
FCC ID: KUTHB318
IC: 4454A-HB318
P/N : 101Y695-001
3M Tape
3M 4905 VHB Tape
TM

If the opener device emits a beep and
the segment LED on the Opener
device does not show P, it means the
set up was successful and you can
control the opener with the HB-318
control.
Press the button Press the button
to close the door
to open the door
3M Tape
How to set up in your car (continue)

Attach the Remote to the installation location (step 1) using the other side of the
3M tape
Remove this remote
To remove the CarHome Button Remote, you will need to peel off the 3M 4905 VHB
tape. We recommend visiting the 3M website (www.3m.com) for guidance on the best
methods to remove 3M 4905 VHB
Change battery
1. Proceed to detach the remote into two parts.
2. Replace the battery by gently pushing out the old battery from the battery slot and replacing
it with a new battery.
NOTE.
Using CR2023 and BR2023 batteries for the best controller performance.
Passcode ON or OFF
By default, the CarHome Button Remote is set to passcode OFF. If you want to turn the
passcode ON, follow these steps:
1. Press and hold the button (about 6 seconds) until the LED blinks quickly. Then release
the button the LED turns off.
2. Enter your password. If this is the first time passcode is turned ON the default factory
password is 222 ( press the
3. Press the button to confirm. The LED will blink 1 time if your password is correct and
the LED will blink 3 times if your password is incorrect.
To turn OFF the passcode, repeat the steps above.
Change passcode
Only change the passcode while the HB-318 has passcode ON.
1. Press and hold the button (about 10 seconds) until the LED blinks slowly. Then
release the button the LED will turn off.
2. Enter your old password (Ex. 222), then press the
If the entered passcode is correct the LED will blink 1 time then you enter your new
passcode and press button to confirm. The LED will blink 1 time if the password was
changed successfully.
If the entered passcode is incorrect the LED will blink 3 times and exit the setup
program.
The passcode can be 2 to 8 digits. Number 1 is
Complete installation
tape from your automobile.
TM
button 3 times )
button to confirm.
button. Number 2 is
TM
button.