1. Manuals
  2. Brands
  3. MEM Manuals
  4. Power Tool
  5. TQA-4050
  6. Operating instructions manual

MEM TQA-4050 Operating Instructions Manual

Heat press
Hide thumbs

Advertisement

Table of Contents

OPERATING INSTRUCTIONS
for the heat press
MEM TQA-4050
Congratulations on purchasing a MEM heat press!
Please read these operating instructions carefully so you can start production with your press
without problems. Reproduction of these operating instructions in any form requires the written
approval of MEM. We reserve all rights to change technical data and product features.
MEM does not assume any liability for direct or indirect damage resulting from use of this
product.
Version 1.2 (09.06.2022)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TQA-4050 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for MEM TQA-4050

Summary of Contents for MEM TQA-4050

  • Page 1 Reproduction of these operating instructions in any form requires the written approval of MEM. We reserve all rights to change technical data and product features. MEM does not assume any liability for direct or indirect damage resulting from use of this product.

  • Page 2: Brief Overview

    Do not open the cover or attempt to modify the machine yourself without instruction.  In case you are requested by the MEM customer support to open the heating plate cover, please make sure you are wearing respiratory protection and only touch the contained insulation wool with gloves.

  • Page 3: Machine Description

    Machine description a. Power switch b. Two hand control press buttons (works on manual mode) c. Temperature controller d. Manual/automatic switch button e. Emergency stop button Handle g. Air reducing valve h. Heat plate Bottom platen Bottom pressure balancing system k.
  • Page 4 (reset after power off) function that counts the number of transfers that have already been made during the current session could be enabled, contact MEM for counter function enable instruction. Press and hold SET button to enter parameter setting interface, press and hold SET button to exit parameter setting interface.

  • Page 5: Operation

    Operation Pneumatic connection  TQA-4050 requires air compressor with minimum 800w (1 hp) and 30L (8 gallon) hold tank.  Connect 5mm inner diameter (usually 8mm outer diameter) air hose to the machine. Charge the compressor to 0.6-0.7 Mpa, up to 0.8 Mpa (120 psi) if possible.

  • Page 6: Maintenance And Cleaning

    Clean the press regularly with a soft cloth and mild household cleaner to remove adhesive residues etc. Technical data Model TQA-4050 220V (2700W) or 110V (1800W) Voltage and power Check voltage at back side of the head Time Range 0-999sec.

  • Page 7: Circuit Diagram

    Circuit diagram...

  • Page 8: Statement Of Conformity

    Statement of Conformity CE certification We herewith declare that the product meets the provisions of the following EC Directives and Harmonized Standards: Certificate Number: M.2020.206.C9752  2006/42/EC Machinery Directive  2014/35/EU Low Voltage Directive  Related Standards: EN ISO 12100:2010, EN 60204-1:2018 RoHS test We herewith declare that the product conforms to RoHS Directive 2011/65/EU Annex II amending Annex (EU)2015/863...

Table of Contents