Table of Contents
Advertisement
Fix the door panel to the top hinge with a screw in
the vertical slot.
Fit bottom guide block G using two screws and fix
the hinge with the screw in the vertical slot (Fig. 9).
Repeat these operations for the other top door.
Check the horizontal alignment of the door panels
and adjust if necessary (Fig. 10).
Re-open the door and drill with a 2.5 mm bit in the
centre of the horizontal slots in the hinge.
Fix with the screws and remove those from the ver-
tical slot (Fig. 11).
Check the vertical alignment of the doors and cor-
rect their position if necessary (Fig. 12).
22
Fig. 9
G
Fig. 10
Level the front faces of the door panels by slacken-
ing the guide block screws and inserting the shims
supplied, as necessary (Fig. 13).
Fig. 11
Fig. 12
Fig. 13
Advertisement
Table of Contents
