Advertisement
Advertisement
Table of Contents
Related Manuals for Asus VIVOBOOK M6400R Series
Summary of Contents for Asus VIVOBOOK M6400R Series
- Page 1 ASUS VIVOBOOK M6400R Series Repair Manual...
- Page 3 Service Overview • ASUS is not responsible for direct, indirect, intentional o unintentional damages resulting from improper installation and operation. • Carefully read through this Service Guide for a look at various components of the device before performing any service and repairs.
- Page 4 Pre-repair checklist • Read the entire manual before starting any service procedures and follow all instructions. • Back up the data on your device. • Place your device on a clean and stable surface. • Turn off your device. • Disconnect all connected peripherals and cables.
- Page 5 ASUS VIVOBOOK M6400RC Overview Top View Bottom View ❶ Array microphones ❷ Webcam shield ❶ Air vents ❸ Camera ❷ Audio speakers ❹ Camera indicator ❺ Display panel ❻ Microphone indicator ❼ Keyboard ❽ Capital lock indicator ❾ Touchpad/NumberPad ❿ Camera indicator ⓫...
- Page 6 Components Top View ⧫ BASE CASE ⧫ MAIN BOARD ⧫ BATTERY ⧫ HINGE CAP ⧫ BATTERY CABLE ⧫ KEYBOARD MODULE ⧫ IO BOARD ⧫ HINGE ⧫ EDP CABLE ⧫ SPEAKER ⧫ LCD COVER MODULE ⧫ SSD ⧫ POWER EXTEND BD ⧫...
- Page 7 Components Bottom View ⧫ BASE CASE ⧫ MAIN BOARD ⧫ THERMAL MODULE ⧫ KEYBOARD MODULE ⧫ IO BOARD ⧫ DMIC RUBBER ⧫ LCD COVER MODULE ⧫ POWER EXTEND BD ⧫ BTM RUBBER BTM REAR RUBBER BTM FRONT RUBBER R/L ⧫ LCD BEZEL ⧫...
- Page 8 Repair Overview This chapter describes disassembly and assembly (Assemble document please look up from the last page), please follow the information provided in this section to perform the complete disassembly procedure. ♦ Precautions: Before you perform any service or repair on the notebook, please pay special attention to the cautions prevent any damages to the notebook. 1.
- Page 9 M6400RC Appropriate Tools Please prepare and select the appropriate tools to disassemble/assemble. ♦ Screwdriver ♦ Alcohol 95% ♦ Glove ♦ Dust-free Cloth Please accord to different screw specification to choose different screwdriver and head. ♦ Plastic Blade ♦ Thermal Pad ♦...
-
Page 10: Bottom Case
BOTTOM CASE Disassembly Notice Screws Spec Torque (kgf-cm) Step 1 : Remove screws *9 pcs. SCREW M2.5*10L(4.6,0.8)(K) W-NI T6 2±0.2 Step 2 : Use plastic blade to pry the bottom case. SCREW M2*4L (4.6,0.8) (K) W-NI T6 2±0.2 SCREW M2*3.5L+6 (4.6,0.8) (K) B-NI T6 2±0.2 Unscrew Start... - Page 11 DISCONNECT BATTERY CONNECTOR Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Before disassembly battery connector, please be sure to pull out adapter and disconnect the battery more than ten seconds in order to IC damage. Step 1 : Use the non-conductive pry tool to push iron sheet.
- Page 12 Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Step 1 : Remove the screw*1pc and SSD. Screws Spec Torque (kgf-cm) Step 2 : Remove the THERMAL PAD and tear off the SSD Thermal Graphite Sheet from M.2 card (SSD). SCREW M2*3L (K) B-ZN #1 NY 2.0±0.2 Please keep these parts, it will be reused for new SSD...
- Page 13 Assembly Notice Please be sure to pull out adapter and disconnect the battery. Paste the SSD Thermal Graphite Sheet on the new M.2 card (SSD), then paste the 1. Align and insert the new M.2 card into the module slot. THERMAL PAD*1pc.
- Page 14 BATTERY Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Before disassembly battery connector, please be sure to pull out adapter and disconnect the battery more than ten seconds in order to IC damage. Step 1 : Remove screws*6 pcs. Step 2 : Remove BATTERY.
- Page 15 WIFI CARD Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Step 1 : Disconnect RF cable*2pcs. Screws Spec Torque (kgf-cm) Step 2 : Remove the screw 1pc. SCREW M2*3L (K) B-ZN #1 NY 2.0±0.2 Step 3 : Remove the WIFI CARD. Disconnect Assembly Notice Please according to below image to assemble RF cable.
- Page 16 SPEAKER Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Step 1 : Disconnect the SPEAKER connector, remove TOP CASE ACETATE TAPE *3pcs. Step 2 : Remove SPEAKER. Disconnect Assembly Notice For Speaker assembly, please follow the mark below to tidy cable. Remove TOP CASE ACETATE TAPE Back...
-
Page 17: Wifi Antenna
WIFI ANTENNA Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Step 1 : Remove the ANTENNA*2pcs. Assembly Notice For new ANTENNA assembly, please follow the mark below to tidy cable. MAIN TOP CASE ACETATE TAPE Remove Back... - Page 18 Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Step 1 : Disconnect FAN connector and EDP cable. Screws Spec Torque (kgf-cm) Step 2 : Release the EDP cable. SCREW M2*4.5L (4.5,0.8) (K) #1 2.0±0.2 Step 3 : Remove screws *4pcs and the FAN. Assembly Notice Please use the correct technique to take Unscrew and remove...
- Page 19 IO BOARD Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Screws Spec Torque (kgf-cm) Step 1 : Disconnect IO BD connector. Step 2 : Remove screws*3pcs. SCREW M2.5*5L (K) W-NI,NY 2.5±0.2 Step 3 : Remove IO board, LED SPONGE & IO FFC. SCREW M2*4.5L (4.5,0.8) (K) #1 2.0±0.2 SCREW M2*4.5L (4.5,0.8) (K) #1...
- Page 20 MAIN BOARD (with THERMAL) Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Screws Spec Torque (kgf-cm) Step 1 : Disconnect (yellow mark) connector*4pcs. Step 2 : Remove screws*5pcs for MB. SCREW M2.5*5L (K) W-NI,NY 2.5±0.2 Step 3 : Remove MB from Top case.
-
Page 21: Thermal Module
THERMAL MODULE Please be sure to pull out adapter and disconnect the battery. Disassembly Notice Step 1 : Please follow the reverse screws numbers to remove screws*8pcs. Screws Spec Torque (kgf-cm) Step 2 : Remove the THERMAL MODULE from MB. SCREW M2*3L (K) B-ZN #1 NY 2.0±0.2 Recommend that the force point is at green block, and pull up thermal module to take... -
Page 22: Main Board
MAIN BOARD Mainboard connector placement EDP CABLE IO FFC SPEAKER BATTERY TP/MB FFC K/B FPC Back... - Page 23 MAIN BOARD Materials on mainboard GPU MYLAR MB ABSORBER AMD CPU MYLAR SSD MYLAR Back...
-
Page 24: Number Pad
NUMBER PAD Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Step 1 : Disconnect and remove the TP FPC. Screws Spec Torque (kgf-cm) Step 2: Release the TP GASKET TAPE. SCREW M2*2L D7.0 (K) B-ZN #1 2.0±0.2 Step 3 : Remove screws*3 pcs. -
Page 25: Keyboard Module
KEYBOARD MODULE Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Step 1 : Remove FP cable. Step 2 : Remove KB MODULE. Assembly Notice Remove If FFC is damage during disassembly, please replace new one. Here are some samples of FFC damage: Remove Back... -
Page 26: Lcd Bezel
LCD BEZEL Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Step 1 : Insert the Plastic Blade in the HINGE COVER and lift up the HINGE COVER. Step 2 : Remove the HINGE CAP. Step 3 : Remove LCD BEZEL. Step 1-4 Due to some tapes behind the lower edge of bezel, please using plastic blade to teardown the bezel. - Page 27 LCD PANEL and PMIC BD Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Step 1 : Disconnect the Camera cable and remove the PMIC BD. Screws Spec Torque (kgf-cm) Step 2 : Remove screw*10pcs and Hinge*2pcs. Step 3 : Pull out LCD adhesive*2pcs.
- Page 28 LCD BEZEL and PANEL Assembly Notice Please be sure to pull out adapter and disconnect the battery. When reuse the LCD COVER: When reuse the LCD BEZEL : Please paste new PANEL ADHESIVE*2pcs. Please paste new LCD BEZEL ADHESIVE*1pcs. (New LCD COVER already contains PANEL ADHESIVE*2pcs) (New LCD BEZEL already contains paste LCD BEZEL ADHESIVE*1pcs) PANEL ADHESIVE/OLED...
- Page 29 CAMERA Disassembly Notice Please be sure to pull out adapter and disconnect the battery. Step 1 : Disconnect camera connector. Step 2 : Remove camera cable. Assembly Notice Step 3 : Remove camera. Step 4 : Remove DMIC RUBBERS*2 pcs. For Camera assembly, please follow Disconnect the mark below to tidy cable.
Need help?
Do you have a question about the VIVOBOOK M6400R Series and is the answer not in the manual?
Questions and answers