Taoglas EDGE Connect Quick Start Manual

Taoglas EDGE Connect
®
Device Overview
1. To Power On The Device
a. A single press of the Power Button will power on the device.
b. Once the device has initialised, the User LED will flash white 3 times.
2. To Power Off the Device
a. Hold the Power Button for 10 seconds
3. Checking Battery Level
a. Once powered the battery level can be checked by
giving the power button a quick press.
b. The User LED will flash red a number of times in
accordance with the battery level.
0% – 20% 
20% – 40%

40% – 60%

60% – 80 % 
80% – 100% 
4. USB LED Behaviour
a. Once the a USB cable is plugged into the micro-USB port on the left
side of the device, the green USB Power LED will illuminate.
b. If the battery is not fully charged, the red charge status LED
will illuminate until charging is complete.
taoglas.com/iot-support
See
For additional support contact iotsupport@taoglas.com
™
for detailed installation instructions.
Power
Button
User LED
Charge Status
LED
USB Port
User
Button
USB
Power
LED
Light
Sensor