Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Makerfarm Manuals
  4. 3D Printers
  5. Pegasus
  6. Calibration

Makerfarm Pegasus Calibration

Extruder calibration
Hide thumbs
1
2
3
4
5

Advertisement

Quick Links

Download this manual
Updated 11-18-2016

Advertisement

loading
Need help?

Need help?

Do you have a question about the Pegasus and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Makerfarm Pegasus

Summary of Contents for Makerfarm Pegasus

  • Page 1 Updated 11-18-2016...
  • Page 2 Pgs 3-5: Adjusting Stepper Driver Current Pg 6: LCD Menu Pg 7: Shifting Prints Pgs 8-9: Hot End Jamming/ Hobbed Bolt Chewing up filament Pg 10: Warping Prints Pgs 11-13: Driver Installation Pg 14: Slow Heating Magma Hot End MaxTemp Error Slow Heating Heat Bed Hot Motors Extruder Motor isn’t turning...
  • Page 3 Pegasus Extruder eSteps The Pegasus has a few different extruders that it can run, each will have a different setting in the firmware (eSteps) to make sure we extrude the correct amount. Below is a list of compatible Pegasus extruders and the standard eSteps setting they should use.
  • Page 4 Changing eSteps via LCD Now that you know the eSteps for your extruder you can change those eSteps via your LCD. 1. Push your LCD knob then turn the knob and highlight Control then push the LCD knob 2. Next turn the knob and highlight Motion then pusht the LCD knob.
  • Page 5 1. Make sure the tension on your extruder springs is correct, if you have a printed pegasus extruder the springs will measure 11mm in length when filament is installed.