Download Print this page

SNAP CIRCUITS HOLIDAY TREE LIGHT Quick Start Manual page 2

Advertisement

Assembly:
STEP 2
What is an LED? How does it work?
An LED (Light Emitting Diode) is a semiconductor
device that emits light when activated. They act
as a one-way valve that allows electricity to flow in
only ONE direction. When positioned in the circuit, if
the + side is facing the + terminal of the source, then
electricity will flow through it. If they face opposite
sides, the LED stops all flow of electricity. LEDs are
commonly used as indicator lights and often for home
lighting because they are more energy efficient than
incandescent light bulbs.
Adult Supervision:
Because children's abilities vary so much, even with age groups, adults should exercise discretion as to which experiments are suitable and
safe (the instructions should enable supervising adults to establish the experiment's suitability for the child). Make sure your child reads and follows all of the relevant
instructions and safety procedures, and keeps them at hand for reference. This product is intended for use by adults and children who have attained sufficient maturity
to read and follow directions and warnings.
WARNING: SHOCK HAZARD -
Never connect Snap Circuits
electrical outlets in your home in any way!
WARNING: CHOKING HAZARD -
!
Small parts. Not for children under 3 years.
X3
Batteries:
If you have any problems, contact: ELENCO
150 Carpenter Ave. Wheeling, IL 60090 | (800) 533-2441 | support@elenco.com | elenco.com
SC-HOLTR1_manual_F.indd 2
SC-HOLTR1_manual_F.indd 2
Enjoy Your Holiday Tree
• Place the mounting base on the LED, then place
the holiday tree in the mounting base. For best
effects, place the circuit in a dimly lit room.
• Unsnap one side of the COLOR2 LED to turn off.
WARNING:
This toy products flashes that may trigger epilepsy in sensitised individuals.
If any parts are missing or damaged,
to the
®
DO NOT RETURN TO RETAILER.
e-mail us at: support@elenco.com.
You may order additional / replacement parts:
elenco.com/replacement-parts
● Use only 1.5V AA type, alkaline batteries
(not included).
● Insert batteries with correct polarity.
● Do not mix old and new batteries.
● Remove batteries when they are used up.
● Do not mix alkaline, standard (carbon-zinc),
or rechargeable.
Copyright © 2024 ELENCO
IMPORTANT:
WARNING:
on a circuit. Never leave a circuit unattended while
the batteries are installed. Never connect additional
batteries or any other power sources to your circuits.
● Do not connect batteries or battery holders in parallel.
● Do not short circuit the battery terminals.
● Never throw batteries in a fire or attempt to open its outer casing.
● Batteries are harmful if swallowed, so keep away from small children.
● Non-rechargeable batteries should not be recharged.
Rechargeable batteries should only be charged under adult supervision,
and should not be recharged while in the product.
ELECTRONICS, LLC
®
753355
®
Electronics, LLC. All Rights Reserved.
Batteries: X3
Install three (3) "AA" batteries
(Full battery installation and warnings
located within this manual)
Always check your wiring before turning
This instruction manual must be retained
since it contains important information.
4/5/24 2:51 PM
4/5/24 2:51 PM

Advertisement

loading
Need help?

Need help?

Do you have a question about the HOLIDAY TREE LIGHT and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Scholtr1