Advertisement
Quick Links
OVERVIEW
Thank you for purchasing our AMP-2 Sensor Board.
AMP-2 Sensor Board is specially designed for the Aqua-X lrrigation Control System. With a male-to-male
signal cable (mini-DlN terminal), this unit acts as a bridge between the sensors (pH Sensor & EC/Temp
Sensor)and the Aqua-X Controller. The pH level, EC level and water temperature will be shown on the LCD
screen of the Aqua-X master controller.
FEATURES
Simpe-to-Use DlN Type Bracket for Easy Installation
●
BNC Terminal (left) for connecting pH Sensor
●
Mini-DlN Terminal (right) for connecting EC/Temp Sensor
●
Mini-DlN Terminal (middle) for connecting Aqua-X Controller
●
Sensor Board (AMP-2)
User Manual
AMP-2
For Aqua-X Irrigation Control System
01
Advertisement
Related Manuals for TrolMaster AMP-2
Summary of Contents for TrolMaster AMP-2
- Page 1 Thank you for purchasing our AMP-2 Sensor Board. AMP-2 Sensor Board is specially designed for the Aqua-X lrrigation Control System. With a male-to-male signal cable (mini-DlN terminal), this unit acts as a bridge between the sensors (pH Sensor & EC/Temp Sensor)and the Aqua-X Controller.
- Page 2 INSTALLATION Mount the Sensor Board near pH Sensor and EC/Temp Sensor in the Aqua-X Control System. Use two screws to mount the Sensor Board on the wall.
- Page 3 OPERATION INSTRUCTIONS 1. Connecting to Aqua-X Use a male-to-male signal cable to connect the Sensor Board to the Aqua-X Controller. Plug the min-DlN cable connector of the signal cable into the SENSOR BOARD terminal on the bottom of the Aqua-X Controller.
- Page 4 Opening the controller will void the warranty. If the surface of AMP-2 Dry Contact Board is dirty, wipe it with a dry towel. The AMP-2 Dry Contact Board operates under natural ventilation conditions. AVERTISSEMENT NE PAS exposer la carte de contact sec AMP-2 à...
Need help?
Do you have a question about the AMP-2 and is the answer not in the manual?
Questions and answers