Keep the equipment clean - you will find this less of a
Operating & Safety Guide 948
chore if you clean it regularly, rather than wait until the
end of the hire period.
Damaged hoses are dangerous so handle them
with care and coil them neatly without kinks when
Hire Shops
storing.
When not in use, store the equipment somewhere
clean, dry and safe from thieves.
FINISHING OFF
Switch the compressor OFF and open its
secondary air tap to release all stored pressure. As
a precaution, operate the air nailer on scrap timber
to check that the compressor is decompressed.
Disconnect the unit from the air supply hose and
give the unit a final clean up ready for return, to
your local HSS Hire Shop.
Pneumatic
Contact your local
Air Nailer
0845 728 2828
For the secret nailing of standard
tongue and groove floorboards to
wooden joists. Also suitable for solid
hardwood overlay boards to wooden
...any comments?
sub-floors.
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
address below
Fax: 020 8687 5001
©HSS Hire Service Group Plc 2000 No. 948/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.co.uk
Code 52512
Need help?
Do you have a question about the 52512 and is the answer not in the manual?
Questions and answers