HSS Hire 52432 Operating & Safety Manual

There are 3 different ways in which the stapler can
be activated...
1. Press the stapler evenly onto the fixing surface
with the safety tip fully depressed, then squeeze the
trigger to fire a staple. Release the trigger and remove
the stapler. This is the safest way to use the unit.
2. As '1' but with the stapler kept in contact with
the fixing surface, slide it to the next fixing point
and squeeze the trigger each time a fixing is required.
3. As '1' but keeping your finger on the trigger, lift
the stapler away from the surface. As you re-locate
the stapler where the next fixing is required, the
staple will fire when the safety tip is fully depressed, this
is known as 'bump firing'.
When 'bump firing' do not bump the tool' s nose
too hard. You need apply only just enough force to
make the safety tip retract and the Stapler will do the rest.
Always control the Stapler with both hands.
Try the stapler on a test area first, if the staple has
been fired too far in or not enough into the surface, the
setting can be adjusted as required.
To do this simply turn the impact adjuster
clockwise to increase pressure, or anti-clockwise
to decrease.
Only use the stapler for fixing onto timber. Do
not attempt to fix to thin weak edges or over an
existing fixing.
Never tamper or modify any safety features on this
equipment, they are there for your safety.
EQUIPMENT CARE
Never push the equipment beyond its design
limits. If it will not do what you want with reasonable
ease, assume you have the wrong tool for the job. Ask at
your local HSS Hire Shop for advice.
Regularly check the condition of the equipment, if
it shows signs of damage or excessive wear, contact your
local HSS Hire Shop for a replacement.
Keep the equipment clean. You will find this less of a
chore if you clean up regularly, rather than wait until the
end of the hire period.
Use only staples supplied by HSS, any other make
may damage both the work and the stapler.
When not in use, store the equipment somewhere
clean, dry and safe from thieves.
FINISHING OFF
Remove the battery and any remaining staples
from the unit.
Thoroughly clean the Stapler, neatly coil the
chargers flex and place together in the carrying
case ready for return to your local HSS Hire Shop.
Contact your local
0990 282828
...any comments?
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
address below
Fax: 0181-687 5001
©HSS Hire Service Group Plc 1998 No. 844/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.co.uk
Operating & Safety Guide 844
Hire Shops
Cordless
Stapler
For tacking paper and fabric
to wood.
Code 52432