Download Print this page

BOA NINJA Programming Instructions

Electronic lock

Download this manual

NINJA Electronic Lock

Programming Instructions

Determine desired application – see figures 1-4

NOTE: Program lock before installation so you can verify read range through the door!

Initializing the Ninja lock(s) to the

Programming Card

1. Press the push-button on the back of the Ninja

Lock.

2. The lock will make a ticking sound (signal).

Place the programming card in contact with the

lock within 3 seconds of hearing this signal.

3. Two short rising tone signals confirm that the

programming card has been initialized.

4. If you are setting up multiple Ninja Locks and

would like to utilize one programming card

repeat the above steps for all other Ninja Locks

in the same system with the same programming

card.

586 New York Avenue, Unit #3, Huntington, NY 11743

Tel: 516 576 0295 | Fax: 631 470 8099 | sales@boasecuritytechnologies.com

PROGRAMMING INSTRUCTIONS

Note: Multiple locks must be separated by

these minimum distances for optimum

operation and battery life.

Note orientation.

Need help?

Do you have a question about the NINJA and is the answer not in the manual?

Page 1 Programming Card these minimum distances for optimum operation and battery life. Note orientation. 1. Press the push-button on the back of the Ninja Lock. 2. The lock will make a ticking sound (signal). Place the programming card in contact with the lock within 3 seconds of hearing this signal.
Page 2 NINJA Electronic Lock Programming Instructions INSTALLATON Installing the Lock Body Add a User Card of Keyfob Carefully drill the first mounting hole with a 7/64” Place the programming card in contact with (2.77mm) drill bit (see diagram below). The front face...