Download Print this page

JoyStar Angel Owner's Manual

Juvenile bicycle

Advertisement

Quick Links

Version 1. 240703
Angel
BIKE050

Advertisement

loading
Need help?

Need help?

Do you have a question about the Angel and is the answer not in the manual?

Questions and answers

Summary of Contents for JoyStar Angel

  • Page 1 Version 1. 240703 Angel BIKE050...
  • Page 4: How To Get Help

    HOW TO GET HELP? Here are something info we need to serve you better! Frame number that Video or picstures Detailed description beneath the bottom showing problem bracket PLEASE CONTACT joystar_service@joykie.com...
  • Page 5: Before The Assembly

    Please avoid the following situations. " The pedals will be too close to the front wheel if front fork is reversed (partial model). Figure 1.1 Reflectors Basket Toolset Saddle Joystar Pedals Figure 1.1 Remove protec film and plastic protector Please dispose as recyclalble...
  • Page 6: Attach The Front Wheel

    ATTACH THE FRONT WHEEL Turn the reversed front fork back. Please make sure the red arrow facing the front of the bicycle. Figure 1.3 Remove nuts and safety hooks (attached on wheel axle) from both sides.Figure 1.2 Figure 1.2 Position the front fork in as Figure 1.3 Evenly tighten up the nuts of both sides at the same time.
  • Page 7 Remove the plastic lid off. Figure 1.4 Figure 1.4 Figure 1.5 Tighten the stem binder bolt clockwise. Figure 1.5...
  • Page 8 Front Wheel Front Wheel There are left and right pedal, please refer to the Rear Wheel Rear Wheel following diagram for the locking direction. Must use a wrench to tighten the pedals, in order to Figure 1.6 avoid stripped threads while riding. In good condition Stripped threads...
  • Page 9 Check the screws, tighten up if screws are loose. Figure 1.7...
  • Page 10 (If the bike is equipped with a kickstand, it does not need to be installed.) Figure 1.8...
  • Page 11 ATTACH THE REFECTORS AND BELL Install the red reflector on the seat post and the white one on the handelbar. Also please do put on the silicon protector.
  • Page 12 ATTACH THE BASKET Pass the two plastic buckle through the basket, encircle the handlebar, and buckle the end of an inverted triangle shape in a suitable position. ATTACH THE RIBBON Insert the ribbon into the holes on each side of the handle sleeve.
  • Page 13 Final step, make sure you follow these steps to finish your installation. NOTE: Federal regulations require every bike over 16 inch to be equipped hand brake. Bicycle under 16 inch are considered ”sidewalk bicycles” and may not be fitted with hand brake. NOTE: Federal regulations require every bike over 16 inch to be equipped hand brake.
  • Page 14 Figure 1.12 Figure 1.11 Figure 1.11 Figure 1.12...
  • Page 15 Figure 1.14 Figure 1.11 Figure 1.14 Figure 1.13...
  • Page 16 Figure 1.15 Figure 1.15 Figure 1.16 Figure 1.16...
  • Page 17 11. This manual cannot cover the installation and maintenance methods for model, and the technical details shown in texts and illustrations in the manual may also change, so please contact JOYSTAR if you cannot find answers to your technical problems.