Advertisement
Quick Links
Advertisement
Related Manuals for JoyStar Unicorn
Summary of Contents for JoyStar Unicorn
- Page 1 Version 1. 240703 Unicorn BIKE049...
-
Page 4: How To Get Help
HOW TO GET HELP? Here are something info we need to serve you better! Frame number that Video or picstures Detailed description beneath the bottom showing problem bracket PLEASE CONTACT joystar_service@joykie.com... - Page 5 Bearing The pedals will be too close to the front wheel if Reflectors Ribbon Bell Lids front fork is reversed (partial model). Figure 1.1 Toolset Seatpost Joystar Pedals Figure 1.1 Remove protec film and plastic protector Please dispose as recyclalble...
- Page 6 ATTACH THE FRONT WHEEL Remove nuts and safety hooks (attached on wheel axle) from both sides.Figure 1.2 Figure 1.2 Position the front fork in as Figure 1.3 Evenly tighten up the nuts of both sides at the same time. Figure 1.3...
- Page 7 Figure 1.4 Remove the plastic lid off. Figure 1.4 Adjust the reversed handlebar back. Figure 1.5 Figure 1.5 Figure 1.6 Tighten the stem binder bolt clockwise. Figure 1.6...
- Page 8 Front Wheel Front Wheel There are left and right pedal, please refer to the Rear Wheel Rear Wheel following diagram for the locking direction. Must use a wrench to tighten the pedals, in order to Figure 1.7 avoid stripped threads while riding. Stripped threads In good condition...
- Page 9 Insert the seat post into the saddle clamp. Tighten the side nuts. 1. Slightly loose the nuts on both sides of saddle clamp if failed to insert 2. Tighten the screws up after the seat post is inserted.
- Page 11 ATTACH THE REFECTORS BELL AND RIBBON Figure 1.11 Install the red reflector on the seat post and the white one on the handelbar. Figure 1.11 1.12 Also please do put on the silicon protector.
- Page 12 There are 2 leather straps, open the buckles and wrap the straps around the handlebar, then buck- led up. ATTACH THE DOLL SEAT ❶ Insert the steel into the doll seat. Tighten up the screw and nut to connect the steel and the doll seat.
- Page 13 Final step, make sure you follow these steps to finish your installation. NOTE: Federal regulations require every bike over 16 inch to be equipped hand brake. Bicycle under 16 inch are considered ”sidewalk bicycles” and may not be fitted with hand brake. NOTE: Federal regulations require every bike over 16 inch to be equipped hand brake.
- Page 14 Figure 1.12 Figure 1.11 Figure 1.11 Figure 1.12...
- Page 15 Figure 1.14 Figure 1.11 Figure 1.14 Figure 1.13...
- Page 16 Figure 1.15 Figure 1.15 Figure 1.16 Figure 1.16...
- Page 17 11. This manual cannot cover the installation and maintenance methods for model, and the technical details shown in texts and illustrations in the manual may also change, so please contact JOYSTAR if you cannot find answers to your technical problems.
Need help?
Do you have a question about the Unicorn and is the answer not in the manual?
Questions and answers