Quick Start Guide BLUETOOTH BUTTON TWS BUTTON Short Press : Pairing On Short Press : TWS pairing Long Press : Unpair unit Long Press : Turn off Glow Illumination Illumination Glow Glow “+” Short Press : Volume Increase “-” Short Press : Volume Decrease “+”...
Page 4
What’s in the Box? 1x Main Unit 1x Type-C to C Charging Cable BLUETOOTH BUTTON TWS BUTTON Blinking : Searching Blinking : Searching Solid : Connected Solid : Connected Strap Hook Strap Hook (Strap not included) (Strap not included) POWER BUTTON Solid White : Power ON Blinking Red : Battery Low @ 20% with low battery warning tone Blinking White :...
Technical Specifications Transducer 64mm X 2 woofer , 20mm X 2 tweeter , 52 X 90mm X 2 Passive Radiator Rated output Power (80W) 25W X 2 Woofer , 15W X 2 tweeter Frequency Response 50Hz ~ 20kHz Signal to Noise Ratio >80dB Battery Type Li-ion polymer 44WH (eqv to 16.8V/2600mAh)
Page 6
Front 64mm 20mm 52 X 90mm Woofer Silk Tweeter Passive Radiator Back USB TYPE C charging 15V/2A (QC) - Full charge in 90mins...
1 - Connect main SABRE to smart phone. 2 - Press TWS on main SABRE to activate pairing mode(Blinking TWS light). 3 - Press TWS on secondary SABRE to activate search mode (Blinking TWS light). SMART 4 - Pairing & Search will start. The successful tone will play, and blinking light will PHONE turn solid when both speakers are connected successfully.
Do not expose Soundstream corrodes the connector surface over time if not rinsed off after Sabre to water while charging. use. After a liquid spill or rinse, It may result in permanent it is important not to charge your...
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the sabre and is the answer not in the manual?
Questions and answers