Problems With The Load Size Indicator Or Calibrating To Zero - Miele W 2839I WPM Operating Instructions Manual

Problems with the load size indicator or calibrating to zero

Problem
The display indicates
<25%
a load of or no
load size is indicated
when the drum is
full.
The display indicates
a load greater than
<25%
when the drum
is empty.
The fault message:
Zero setting
not possible
appears in the
display.
Possible cause
There was already
laundry in the drum
when the machine
was switched on.
This has decalibrated
the sensor from the
zero setting.
The load size sensor
has been
decalibrated from the
zero setting.
The drum door is
closed.
Problem solving guide
Remedy
^ To recalibrate the sensor to the
zero setting:
– Remove the laundry from the
drum.
– Switch off the washing
machine and leave the door
open.
– Switch on the washing
machine.
– Press the Cottons programme
button.
– Press and hold the Load/
Detergent button pressed in
until the following message
appears in the display:
Zero setting
OK.
Rotate the drum once. If the
display still indicates a load
<25%
greater than
the sensor to zero again (see
above section).
– Open the drum door.
– Switch off the washing
machine and leave the door
open.
– Switch on the washing
machine.
– Try and recalibrate to zero
again.
, recalibrate
43