SAFETY INFORMATION
Requirements concerning safety are
listed in particular sections of this instruction.
Apart from them it in necessary to fulfill the
following requirements.
Prior to starting the assembly, repairs or
•
maintenance and during the execution of
any connection works, it is necessary to
switch off the mains supply and make sure
that no terminals no electrical wires are
energized.
After deactivating the controller, terminals
•
of the controller can be under a dangerous
level of voltage.
The controller can be utilized only in
•
accordance with its intended use.
Values of programmed parameters must
•
be set in accordance with a particular
building and hydraulic system.
Controller can be assembled only by
•
qualified installer and in accordance with
currently valid standards and regulations.
•
The controller is not an intrinsically safe
device. It means that in case of failure it
can be a source of sparks or high
temperature which surrounded by ashes
or flammable gases can cause fire or
explosion.
Modification
of
•
parameters should be made only by a
person who read this manual.
Use only in heat circulation system made
•
in
accordance
regulations.
Electrical system including the controller
•
should be protected with fuse selected in
accordance with used loads.
The
controller
•
damaged housing.
Never make any modifications in controller
•
structure.
•
The controller has electronic disconnection
for connected devices (operation 2.B
according to PN-EN 60730-1).
Before you open casing, first disconnect
•
power supply from the unit.
•
The
controller
accordance with the requirements of EN
60335-1
standard,
authorized technician.
the
programmed
with
currently
valid
cannot
be
used
must
be
installed
by
qualified
Short circuit at the outputs leads to
•
damage to the device (not output COM-
NO).
Do not operate the unit when it is
•
malfunctioning
unauthorized persons.
Do not mount the unit on flammable
•
materials.
with
in
and
4
or
was
repaired
by
Need help?
Do you have a question about the EWT100 and is the answer not in the manual?