SWEEX MI700 Manual

Bluetooth mouse usb

English version

Introduction

Do not expose the Bluetooth Mouse to extreme temperatures. Do not place the device in direct sun light or close to heating

•

elements.

Do not use the Bluetooth Mouse in extremely dusty or moist environments.

•

Prevent hard shocks or impacts of the device, as this can cause damage to the internal electronics.

•

Never try to open the device yourself, this voids the warranty.

•

To use the Bluetooth Mouse, you need a computer which can set up a bluetooth connection. This is possible if your computer or

notebook has a build in bluetooth adapter, or when you have connected an USB bluetooth adapter.

Bluetooth can be configured with several different types of software. Determine which steps you have to follow to connect to the

bluetooth mouse. This manual explains the basic windows and the IVT Bluesoleil software.

To activate the Bluetooth Mouse slide the button to the left to "On".

MI700 Sweex Bluetooth Mouse USB

Table of Contents

Do you have a question about the MI700 and is the answer not in the manual?

Page 1 Operation To use the Bluetooth Mouse, you need a computer which can set up a bluetooth connection. This is possible if your computer or notebook has a build in bluetooth adapter, or when you have connected an USB bluetooth adapter.
Page 2 1. Right click the Bluetooth icon and choose “Add a bluetooth device”. 2. Press the round button at the bottom of the button once. The red light on top of the mouse will start to blink. 3. Place a check mark at “My device is setup and ready to be found”.
Page 3 1. Start your Bluesoleil software. 2. Press the round button at the bottom of the button once. The red light on top of the mouse will start to blink. 3. Choose “My Bluetooth” → ”Bluetooth Device Discovery” and wait until searching is complete, and the mouse has been...
Page 4 5. Enter “0000” (four zero's) as key and press OK. 6. A red check mark appears at the mouse icon. 7. Right click the mouse and choose “Refresh services”. 8. Right click the mouse again and choose “Connect”, then choose “Bluetooth human interface device service”.
Page 5 Important: Be aware that when the mouse is not used for a period of time it will go in to hibernation mode. To re-activate the mouse press one of the mouse buttons once.