iSP Decimator X G String Noise Reduction Manual

The Decimator X G String Noise Reduction pedal is the
latest generation in noise reduction technology. The
Decimator X G String features improved release using
an Integration Release Window that offers the
smoothest, ripple free approach in tracking the envelope
of the input signal. The IRW will instantly respond to
short staccato notes and at the same time provide ripple
free control of long sustained notes while downward
expanding. The Decimator pedal is easy to use and
simple to operate
The threshold control on the Decimator X G String
should be adjusted by listening to the noise floor while
no instrument signal is present. The threshold control
should be turned clockwise until the noise floor becomes
inaudible. It may be necessary to readjust the threshold
with the guitar volume all the way on in order to
accommodate the additional noise the guitar may
induce. Adjusting the threshold too far clockwise may
cause the downward expander to attenuate the output
level too quickly and not allow the signal to decay
naturally.
BATTERY / ADAPTER
To install the battery, loosen the thumbscrew shown
above and raise the switch cover to allow access to the
battery compartment. Insert a 9v battery to the
connector and place the battery into its compartment
and close by holding the switch cover down and
tightening the thumbscrew.
To use the Decimator II with an external power adapter,
select an adapter with at least 100 milliamps capability at
9 volts DC. Make sure the adapter is polarized "TIP
NEGATIVE".
CONNECTIONS
The Decimator X G String has 4 ¼ inch jacks.
Connect the guitar directly to the Guitar IN.
Connect the Guitar OUT to the input of the
amplifier. Connect the DEC IN to the loop send
and DEC OUT to the loop return. For best
performance place all gain pedals in front of the
amplifier and DEC IN. You can put Delay and
Reverb effects pedals after the Decimator X G
String and before the loop return to avoid
cutting off reverb and delay tails.
WARRANTY & SERVICE
The warranty data must be filled out on line at
www.isptechnologies.com
warranty. This unit parts and workmanship are fully
guaranteed to be free of defects under normal use and
service for a period of three years from date of
purchase. Any damage resulting from misuse of the
failure to follow the precautions and instructions will
void the warranty. In the event that the unit needs to be
repaired, please return the unit to ISP Technologies
directly. Simply re-pack the unit, send a copy of your
original receipt, a note stating the problem and send it
to:
ISP Technologies
5479 Perry Dr. Suite B
Waterford, Mich.48329
ATTEN: Repair Dept.
All shipping charges must be prepaid. ISP will not be
responsible for any damages incurred in shipping the
unit. Any claim will need to be settled with the shipping
company. The warranty will be voided if the serial
number has been tampered with. Should you have any
questions for the repair dept prior to returning the
product please
www.isptechnologies.com
in order to activate the
call 248-673-7790