Advertisement
English
ASSEMBLY INSTRUCTIONS
Your table fan comes completely assembled and
is ready for immediate use carefully unpack your
fan, refer to the operating instruction below and
enjoy.
MAINTENANCE INSTRUCTIONS
CLEANING:
Always unplug the fan before cleaning or
disassembling. Be sure to use a soft cloth
moistened with a mild soap solution.
Do not immerse fan in water or allow water to
drip into the fan housing. Avoid the use of
gasoline, benzine, thinner, etc. This will result in damage plug to the fan.
The following three steps are suggested for cleaning the blade.
1. Use a screwdriver to open the clips on the front guard frame to remove the front guard from the rear
guard.
2. Clean the blade with a soft cloth, moistened with a mild soap solution.
3. Secure the front guard to the rear guard with clips after cleaning.
STORAGE:
1. Clean thoroughly and store in the original box.
FAN OPERATION:
1. Set fan base on a dry, level surface.
2. Plug cord into any standard 120V AC 60Hz outlet making sure the speed control is at OFF.
ADJUST THE VERTICAL ANGLE
1. To adjust the vertical angle, hold fan guard and loosen the vertical setting knob. Adjust the fan to the
desired vertical angle then tighten the vertical setting knob.
OSCILLATING CONTROL
1. Pull the oscillating pin upward to keep the fan in a stationary position.
2. Push the oscillating pin downward for a 90-degree oscillating movement.
2
Advertisement
