In no event shall ARRI or its subsidiaries be liable for or have a remedy for recovery of any special, direct, indirect, incidental, or consequential damages, including, but not limited to lost...
The information and intellectual property contained herein is confidential between ARRI and the client and remains the exclusive property of ARRI. If you find any problems in the documentation, please report them to us in writing. ARRI does not warrant that this document is flawless.
Overview EJW-1 ..........................15 Pin Out LBUS Interface........................15 Mounting and Assembly..........................16 To Mount the Clamp Bridge 52 to EJS-1 .................... 16 To Mount the Clamp Bridge 52 to EJW-1 ................... 16 To Wire LBUS / FS-CAN Bus......................16 Communication Cables ........................
Our advanced service training courses are designed to transfer detailed knowledge about how to service and repair all types of ARRI products and give you permanent access to detailed service instructions, special tools and service parts. To learn more, please visit...
Always follow the recommended measures to avoid this situation. HINT Not relevant to safety, HINT provides additional information to clarify or simplify a procedure. External Joystick Broadcast EJS-1 External Jog-Wheel EJW-1 User Manual...
Page 8
Before use, read and follow all relevant instructions. Use solely and exclusively as described in the instructions. Always use original ARRI / cmotion LBUS cables to external power sources (D-Tap, XLR). ARRI/cmotion LBUS cables to external power sources provide a protection circuit to prevent back currents to power supplies/batteries.
Page 9
Always follow the manufacturers instructions. Use only External Joystick Broadcast and External Jog-Wheels components approved by ARRI. The use of components not approved by ARRI is at your own risk. Obey all relevant safety guidelines. External Joystick Broadcast EJS-1 External Jog-Wheel EJW-1 User Manual...
Page 10
Installation and operation must be done by trained personnel. Always read and understand the operating instructions of third-party accessories before you mount recommended the accessories (such as pan bar arm). Always use the tools specified by the manufacturer. External Joystick Broadcast EJS-1 External Jog-Wheel EJW-1 User Manual...
5 About this Product The External Joystick Broadcast EJS-1 can be used as an alternative to the ARRI wheels DRW-1. It controls the pan, tilt, and roll axis of the TRINITY 2 and 360 EVO Remote Head via the Remote Control Panel RCP-2.
Always store, ship and dispose according to local regulations. ARRI is not liable for consequences from inadequate storage, shipment or disposal. On delivery, please check if package and content are intact. Never accept a damaged or incomplete delivery.
• 2x K2.0006750, Cable LBUS – LBUS (0.3 m / 1 ft) • 2x K2.0042837, CSS Clamp Bridge 52, 19 mm For scope of warranty, please ask your local ARRI Service Partner. ARRI is not liable for consequences from inadequate shipment, improper use or use of third-party products.
Page 14
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. External Joystick Broadcast EJS-1 External Jog-Wheel EJW-1 User Manual...
Lemo 0B 4pin (24 V max. 3 A) Pin 1 Ground Pin 2 CAN Low Pin 3 + 12 V / + 24 V Pin 4 CAN High *Shown from mating side External Joystick Broadcast EJS-1 External Jog-Wheel EJW-1 User Manual...
7 | Mounting and Assembly 7 Mounting and Assembly To attach the EJS-1 and EJW-1 to 19mm rods, you must attach the CSS Clamp Bridge to the underside of both housings. 7.1 To Mount the Clamp Bridge 52 to EJS-1 •...
Before use, read and follow all relevant instructions. Use solely and exclusively as described in the instructions. Always use original ARRI / cmotion LBUS cables to external power sources (D-Tap, XLR). ARRI/cmotion LBUS cables to external power sources provide a protection circuit to prevent back currents to power supplies/batteries.
Risk of injury and damage. Do only carry out maintenance work that is describes in this operating manual. Do not try to repair the device yourself. Repairs may only be carried out by authorized ARRI service partners. For repairs and maintenance work on the device, please contact the ARRI Service.
Page 19
PARLIAMENT AND OF THE COUNCIL of June 4, 2012 on waste electrical and electronic equipment (WEEE II). Accordingly, this product must not be disposed of with household waste. There are the respective country-specific disposal rules that must be observed. External Joystick Broadcast EJS-1 External Jog-Wheel EJW-1 User Manual...
• Do not store the product outside of the specified ambient temperature range. • Do not store the product in places where it may be subject to extreme temperatures, direct sunlight, high humidity, severe vibration, dust or strong magnetic fields. External Joystick Broadcast EJS-1 External Jog-Wheel EJW-1 User Manual...
Need help?
Do you have a question about the EJS-1 and is the answer not in the manual?
Questions and answers