Page 1
Imprint Microforce Joystick for SRH Remote Control Panel Installation Guide Date 20.02 2020...
Page 2
In no event shall ARRI or its subsidiaries be liable for or have a remedy for recovery of any special, direct, indirect, incidental, or consequential damages, including, but not limited to lost profits, lost...
Page 3
Table of Contents Table of Contents 1 For your safety 2 Installation 3 Assigning the Controllers...
This product is NOT designed for inexperienced users and should not and must not be used without proper training. ARRI recommends that all users of the SRH-3 and SRH-360 system read the manual in its entirety prior to use. All directions are given from a camera operator's point of view. For example, camera-right side refers to the right side of the camera when standing behind the camera and operating it in a normal fashion.
Page 5
NOTE Carefully lift the existing joystick out of the control panel. 2.6 Placing the Microforce Joystick Note the contour of the joystick cover and insert the joystick in the control panel according to its shape. Place the four Torx screws and tighten them.
Page 6
Place the Torx screws and tighten the screws evenly. Assigning the new controller NOTE SUP 2.3 is required to use the Microforce joystick Assign Pan Setpoint MF1P MF1T 3.1 Assigning Pan • Touching the area below Pan, will open a new touchscreen display menu.