Ezurio ConnexLink CL4790 Series Quick Start Manual

CL4790-1000-232, CL4790-1000-485
Application Note
1 Introduction
The goal of this Application Note is to outline how to configure the CL4790 ConnexLink units with the most basic settings to establish a Point-to-
Point (P2P) or Point-to-MultiPoint (P2MP) connection between two or more CL4790 units.
2 Requirements
Two (or more) CL4790-1000-xxx units (for demonstration purposes we will be working with two CL4790-1000-232 variant)
•
Appropriate USB-to-xxx interface adapters to enable connection to PC – not included with CL4790 units
•
– CL4790-1000-232
RS232-to-USB (examples: FTDI Model: UC232R-10, Tripp-Lite Keyspan Model: USA-19HS)

– CL4790-1000-485 (One of the following)
RS485-to-USB (example: ULinx Model 485USBTB-2W)

RS485-to-RS232 combined with RS232-to-USB adapter (example B&B Electronics Model: 485SD9TB)

PC Operating Windows XP or newer
•
Configuration and Test Utility Software v6.07
•
(Optional) Female-to-Female pin jumper wire (to tie TX/RX RS232 pins for loopback test) or serial loopback plug (example:
•
Female Serial Loopback
3 DOWNLOAD & INSTALL CONFIGURATION SOFTWARE
You will need to download the Configuration and Test Utility Software v6.07
To install the CU follow these steps:
1. Once the files have been downloaded, extract them (right-click on file and select "Extract All ") as shown in
Figure 1: Extract All
https://www.ezurio.com/
from CL4790 Product Page
Adapter)
© Copyright 2024 Ezurio
All Rights Reserved
from the CL4790 Product Page.
1
CL4790 Quick Start
Application Note
v2.0
SeaLevel DB9
Figure 1.
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852-2762-4823