Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for QTech SMS Lite 4G
Summary of Contents for QTech SMS Lite 4G
- Page 1 SMS Lite 4G Workbench Configuration Guide SMS Lite 4G Revision 02...
-
Page 2: Table Of Contents
Connection Tips ............................7 Workbench Categories ..........................7 Workbench Buttons .............................7 Factory Defaults ............................8 Category - Overview ............................9 Firmware Upgrade Process - Rev D Hardware ..............10 Additional Information and Support ................11 SMS Lite 4G–Workbench Configuration Guide © 2024 QTech Data System Ltd. - Page 3 The information in this document is subject to change without notice and does not represent a commitment on any part of QTech Data Systems Limited. While the information contained herein is assumed to be accurate, QTech Data Systems Limited assumes no responsibility for any errors or omissions.
-
Page 4: Introduction
Note - SMS Lite rev D hardware with firmware v4.9 or earlier is not supported by Workbench until it has been upgraded by QTech. Note - SMS Lite rev C hardware is not supported by Workbench until it has been upgraded by QTech. Other documents that should be read in conjunction with this document include: •... -
Page 5: Device Programming Matrix
1. Send the “Info” SMS command to the SMS Lite. Record the firmware version number. If the version number begins with “0.nn” where nn is a 2 digit number then contact QTech for guidance. 2. Remove the case lid and inspect the main circuit board. The hardware board revision is printed in white on the main board and will read “REV D NOV 2021”... -
Page 6: Qtech Workbench
QTech Workbench The SMS Lite is configured using QTech Workbench software via the USB interface. A USB Type A-Mini B cable is required to connect to the device. Installing Workbench QTech Workbench software runs on Microsoft Windows 10 or later. -
Page 7: Connection Tips
Read from Device Returns the current device settings Write to device Saves new configuration settings to the device. REMEMBER TO “WRITE TO DEVICE” WHEN YOU HAVE FINISHED CONFIGURING THE SMS LITE. SMS Lite 4G–Workbench Configuration Guide © 2024 QTech Data System Ltd. -
Page 8: Factory Defaults
Max Phone Numbers Cannot be changed Power On Message Can be changed using Workbench Compact Message Cannot be changed Format Debounce time 0 sec Can be changed using SMS command SMS Lite 4G–Workbench Configuration Guide © 2024 QTech Data System Ltd. -
Page 9: Category - Overview
(yes). This will send out the event notification as fast as possible and suppress any prompts to the user to acknowledge the alarm. There is no need to reply to this form of notification. SMS Lite 4G–Workbench Configuration Guide © 2024 QTech Data System Ltd. -
Page 10: Firmware Upgrade Process - Rev D Hardware
Workbench normally and have the USB drivers installed before you attempt to do a Firmware upgrade. Windows 10 or later must be used. SMS Lite 4G–Workbench Configuration Guide © 2024 QTech Data System Ltd. -
Page 11: Additional Information And Support
Additional Information and Support If you have problems try the following: • Visit the QTech web site for application notes and guides • Refer to the troubleshooting section if one is present in this document • Contact the support desk at techsupport@qtech.co.nz...
Need help?
Do you have a question about the SMS Lite 4G and is the answer not in the manual?
Questions and answers