Page 1
EZ8WSSSMC_1A LZ8WSSSMC_1A Elkay EZH2O Refrigerated Surface Mount Bottle Filling Station(s) series EZ8WS & LZ8WS INSTALLATION MANUAL Patent zurn-elkay.com/patents WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov ADVERTENCIA: Cáncer y daño reproductivo - www.P65Warnings.ca.gov AVERTISSEMENT: Cancer et effets néfastes sur la reproduction - www.P65Warnings.ca.gov...
Change the Unit Type ....13 Change Filter Capacity (Filtered Unit Only) . 13 Resetting the Bottle Count ....14 Elkay Manufacturing Company (630) 574-8484 Page 2...
Elkay reserves the right to change for use by persons having knowledge of this technical specification without notice. area at their own discretion and risk. Elkay assumes no responsibility for results obtained or damage incurred All dimensions are given in inches (") and millimeters from the use of this material either in whole or in part by (mm).
EZ8WSSSMC_1A LZ8WSSSMC_1A 2. Safety 1.6 Warranty This product is covered by a Limited Warranty and Elkay will not be held responsible for damage of any kind in Think Safety connection with the installation of the product. THINK SAFETY! Refer to the Elkay website http://www.elkay.com/...
• If an extension cord is required, always use an OSHA approved extension cord. Placing fingers in or around the cutting blades could result in serious personal injury. (630) 574-8484 Elkay Manufacturing Company Page 5 1000006137 (Rev. D - 06/23)
Page 6
EZ8WSSSMC_1A LZ8WSSSMC_1A Elkay Manufacturing Company (630) 574-8484 Page 6 1000006137 (Rev. D - 06/23)
Pipe should extend 3” (76mm) maximum from wall. c. Install a quarter-turn, installer supplied, shut-off valve. Elkay Manufacturing Company (630) 574-8484 Page 8 1000006137 (Rev. D - 06/23)
5. Install the two mounting screws to attach cooler to the wall. Hanger Bracket 6. Connect the unit water line to shut-off valve. Note: Shut-off valve not shown (installer supplied part). (630) 574-8484 Elkay Manufacturing Company Page 9 1000006137 (Rev. D - 06/23)
Center the mounting plate side to side with the basin. Mark the six (6) mounting holes with a pencil. 6. Feed the power cord and water line through hole on top of the water cooler. Elkay Manufacturing Company (630) 574-8484 Page 10 1000006137 (Rev. D - 06/23)
Page 11
12. Connect all drain and water supply fittings. 13. Turn on water supply. Note: If installing a filtered unit, continue to section 7. If installing non-filtered unit, skip to section 8. (630) 574-8484 Elkay Manufacturing Company Page 11 1000006137 (Rev. D - 06/23)
Note: The first initial dispenses might have air in line which may cause a sputter. This will be eliminated once all air is purged from the line. Scan for trouble shooting and to sign up for auto replenishment of authentic Elkay filters. Elkay Manufacturing Company (630) 574-8484 Page 12...
FLTR = and the display will change to FLTR = 0. 3. The green LED on the bottle filler panel should now be illuminated indicating that the filter monitor has been reset. (630) 574-8484 Elkay Manufacturing Company Page 13 1000006137 (Rev. D - 06/23)
4. Test the bottle filler by placing a hand or a bottle in front of the sensor and dispense product until the bottle count changes to 1. ELKAY MANUFACTURING COMPANY • 1333 BUTTERFIELD ROAD,SUITE 200 • DOWNERS GROVE, IL 60515 • 630.574.8484 • www.elkay.com Elkay Manufacturing Company (630) 574-8484 Page 14 1000006137 (Rev.
Page 15
EZ8WSSSMC_1A LZ8WSSSMC_1A (630) 574-8484 Elkay Manufacturing Company Page 15 1000006137 (Rev. D - 06/23)
Need help?
Do you have a question about the EZ8WSSSMC 1A Series and is the answer not in the manual?
Questions and answers