Throttle Control - FTX Colt Setup Instructions

THROTTLE CONTROL

When at the mid position the model should
remain stationary, if it creeps slightly adjust
the throttle neutral dial accordingly.
BINDING THE TRANSMITTER TO THE CAR
To make sure only one transmitter can control the receiver they need to be matched, and to do so you
need to "Bind" them together so they only recognise each others signature code.
When pulled back to the handset the model
should move forwards, if not flick the
Throttle switch to the 'Rev' position.
The car should come already
factory bound to the transmitter.
To bind again please following
these instructions:
Plug the battery pack to the
speed control. Then turn on the
car via the switch. If you look
inside the car you will see the
steering servo link and 3-in-1
box bind button location. A small
light will flash on the inside of
the 3-in-1 esc/servo/receiver
box when it is turned on.
Then, using a small screw driver
gently press the bind button on
the inside of the box for a few
seconds.
Next turn on the transmitter
switch whilst holding down the
centre bind button at the same
time.
Release the button and the
transmitter and 3-in-1 unit
should bind and be paired. Both
LED on the transmitter will turn
soild red and green.
6
When pushed away the model should brake (and
then move in reverse if applicable) if not simply
flick the throttle switch to the 'Rev' position.
Switch
Bind Button