Page 1
“P u l s e M a s t e r ” pulse induction metal detector User’s guide www.mikronbg.com _______________________________ ______________________________ Made in Bulgaria...
Page 2
. 1. Assembling of the device: Assembling the Pulse Master is simple and you don’t need any special tools. When use the round coil 14” (36cm.): The bearing rod is assembled by inserting of the lower part into the upper one.
Page 3
In order to avoid interference of the metal parts of the electronic unit, be sure to carry the Pulse Master on the side of your body that is away from the search frame. 1. Setting and use Pulse Master: Seeking frame is assembled and is placed on the ground paying attention to the range and there don't have to be any metal objects.
Page 4
Hold for a few seconds the coil / frame above the ground. If the sound signal is changed (increased), lower values of THRESHOLD carefully, until the sound signal disappears or stays to hear the sound "pop" with a low frequency. Pulse Master is tuned and ready to use.
Page 5
Thus the signal from the detected object becomes much shorter. “Pulse Master” can sometimes react by small objects such as big coins or large caps, if they are on the earth surface and within just pass over them, but then hear a short sound of a double crossing of the two arms of the frame over the subject search! “...
4.Charging storage batteries and indications for their status. “Pulse Master” has a built-in accumulator battery 12V/1,3Ah, which is able to provide 15-20 hours of working process without any interruption depending on the chosen power and the type of the used search coil.
Page 7
Protect the environment and always fill back in the holes you have dugged out! 7. Guarantee The detector Pulse Master is offered with 2 years of guarantee of electronics, labor and materials used, for harms which are not caused on purpose or irresponsibly.
Need help?
Do you have a question about the Pulse Master and is the answer not in the manual?
Questions and answers