Sig Indicator - Yamaha MGP12X Owner's Manual

Controls and Connectors
q Effect program display
Displays the program number selected with the PROGRAM
knob (w).
w PROGRAM knob
Selects one of 8 internal effects from FX1 and 16 internal
effects from FX2. Turn the knob to select the desired effect,
and then press the knob to enable it.
See page 28 for details about the internal effects.
NOTE
You can also select the desired effect by turning the knob while
holding it down.
e PARAMETER control
Adjusts the parameter (depth, speed, etc.) for the selected
effect. The last value used with each effect type is saved.
NOTE
When you change to a different effect type, the mixer automati-
cally restores the value that was previously used with the newly
selected effect (regardless of the current position of the
PARAMETER Control knob).
r AUX PRE controls (1, 2)
Each knob adjusts the level of the effect-processed sound sent
to the corresponding AUX1 and AUX2 buses.
t TAP button and indicator
This feature lets you set the delay time (tempo) for FX2 by
tapping on the button. The feature only works when the effect
type for FX2 is set to , DELAY or . SINGLE DELAY.
To set the tempo, tap on the button at the appropriate interval.
The average interval (BPM) at which you tap the button will
be calculated, and that value will be set for the tempo. Con-
tinue tapping as necessary until you get the timing right.
The average interval will be set (the average of a, b, and c)
a
First tap Second tap
The TAP indicator flashes in sync with the tempo when the
, DELAY or . SINGLE DELAY is selected.
NOTE
• The tempo is not set when the average interval at which you
tap the button is out of the range of 80 – 300BPM.
• For more information on the tempo range, see page 28.
• The mixer retains the last tempo setting made, even after the
power is turned off.
22
MGP16X/MGP12X Owner's Manual
b c
Third tap Fourth tap
y ON button
This button turns the corresponding internal digital effect on
or off. When the function is on, the button lights.
NOTE
The On/Off status of the internal effects will be retained, even
when you turn off the power.
u SIG indicator
Lights when an effect signal is input into the channel.
i Bus assign switches
These switches determine the bus(es) to which the signal of
the internal digital effects is sent. Press the switch in (
output the signal to the corresponding buses.
• 1-2, 3-4 switches: Assign to the GROUP 1-2, 3-4
buses.
• ST switch: Assigns to the STEREO L/R bus.
o PFL switch and indicator
When the PFL (Pre-Fader Listen) switch is on (
indicator will light and the pre-FX (1, 2) RTN-fader signal is
output to the MONITOR OUT and PHONES jacks for moni-
toring.
NOTE
If both PFL and AFL switches are turned on, only the PFL
switch is enabled. To monitor the post-fader signal, make sure
to turn off all PFL switches.
!0 FX RTN faders (FX1, FX2)
These adjust the level of the effect sent from the internal
effect to the GROUP 1-2, 3-4 and STEREO L/R buses.
To restore the initial factory settings for the internal effects, turn
on the power while holding the TAP button (t) and the ON
button (y).
) to
), the