Samsung NSE6D 8550 Series User Manual page 61

4. Shake the graphite lubricant before
opening it. Starting with the left (front
and back) slide mechanism of the rack,
place four (4) small drops of lubricant
on the two (2) bottom tracks of the slide
close to the bearing carriers.
5. Repeat for the right (front and back) slide
mechanism of the rack.
6. Open and close the rack several times to
distribute the lubricant.
7. Replace the cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3, 4, 5 and 6.
8. Close the rack, turn rack right-side-up
and place in the oven. See installing the
gliding rack in the USING THE GLIDING
RACK section.
NOTE
• Do not spray the gliding rack with
cooking spray or other lubricant sprays.
Oven door
Don't hand Don't hand
clean the clean the
oven door oven door
gasket. gasket.
You may You may
hand clean hand clean
the door. the door.
Drawer Handle
Remove dust with soft brush or soft cloth covered with water.
• Use soap and water to thoroughly clean
the top, sides, and front of the oven door.
Rinse well. You may use a glass cleaner
on the outside glass of the oven door.
DO NOT immerse the door in water.
DO NOT spray or allow water or the glass
cleaner to enter the door vents. DO NOT
use oven cleaners, cleaning powders, or
any harsh abrasive cleaning materials on
the outside of the oven door.
• DO NOT clean the oven door gasket.
The oven door gasket is made of a
woven material which is essential for a
good seal. Care should be taken not to
rub, damage, or remove this gasket.
CAUTION
• Do not use alkaline detergents,
sulfuricacid, hydrochloric acid, organic
solvents, or disinfectants.
- Surface can be damaged.
English 61