GE Monogram ZBD0710K01SS Owner's Manual page 9

Control Panel/OperaOon
Dishwasher
[] Status Indicator Lights (indicators vat} by model)
The Status display tells you what is happening while the dishwasher is in operation.
The lights will come ON, indicating the sequence of the dishwasher operation.
SENSING Displayed while the ExtraClean r_ Sensor is measuring the aulo/ult of soil and
temperature of water. The dishwasher will at!just the selected cycle to achieve
optimal perfln'mance.
ADD-A-DISH Displayed dm'ing prewash indicating that dishes added now will still be
cleaned.
WASHING Displayed during prewash, main wash and rinse periods.
DRYING Displayed dm'ing HEATED DRY.
SANITIZED Displayed when cycle has met sanitization conditions.
CLEAN Displayed when a wash cycle and enhancements are complete.
["_ Time Remaining Display (on some models)
Dm'ing operation, the display shows the minutes remaining tmtil the cycle is complete. The
display may at!JuS the remaining time while the Sensing light is on. The time displayed at the
sta_ of each cycle may change fl'om the factory setting as the trait customizes itself to home
use. During a delay stare the display will show hours of time remaining until the cycle starts.
[] START/RESET
START--
After selecting the cycle and desired enhancements, press the START/RESET
pad to ready the disi_washer to begin the cycle. Close the door to start the
cycle or begin the DEI,AY START countdown. When the cycle starts, the water
fill begins and approximately 60 seconds later the wash action begins.
The dishwasher will always display your last selection and enhancements. If
you don't want to change the settings, simply press the START/RESET pad to
ready the dishwasher and close the door to begin the cycle.
NOTE: If the START/RESET light is flashing, the cycle has been
interrupted. I,ight will stop flashing after the dishwasher automatically
pumps out the water. Close the door to allow the water to pmnp out (this
takes approximately 70 seconds). When the light stops flashing, the
dishwasher can be reprogrammed and restarted.
Also, if a power fiulure occurs NORMAl, and HEATED DRY will automatically
be programmed. Make any new selections and press the START/RESET pad
to begin the new cycle.
RESET--
Open the door slowly to prevent splash-out. Press the START/RESET pad
to cancel the cycle and close the door. Dishwasher will ptunp out and turn oit
aiter 70 seconds.
['_ Clean--
NOTE: If the START/RESET light is flashing, the cycle has been
inteH upted. I,ight will stop flashing atter the dishwasher automatically
ptu/ips ()sit the water. Close the door to alh)w the water to pmnp out (this
takes approximately 70 seconds). When the light stops flashing, the
dishwasher can be reprogrammed and restarted.
The CI,EAN light is ilhuninated and a double beep will sotmd when the
selected cycle and enhancements are complete. You may remove the dishes
at any time. Note the high-efficiency tim will run quietly fiw 30 minutes to
4 horn's (depending on selected cycle) after the CLEAN light is illuminated
to continue diying the dishes. This can be stopped by opening the door
and pressing any keypad.
NOTE: To turn off the double beep indicator (or re-activate it if it was
previously disengaged), press the HEATED DRY pad 5 times within 3
seconds. A triple beep will sound to indicate the end-oiZcycle beep option
has been toggled.