Download Print this page

Franke Evco 470.778 Instruction Manual

Download this manual

INSTRUCTION MANUAL

Thermostat EVCO

Part no.: 470.778

Signals of the instrument

Turning on/off

LED load, if it is lit, the load will be turned on. If it flashes:

- the modification of the working setpoint will be running

- a load protection will be running (parameters C1 and C2)

LED defrost

if it is lit, the defrost will be running

LED alarm

if it is lit, an alarm will be running

LED Celsius degree

if it is lit, the unit of measure of the temperatures will be Celsius degree

(parameter Uni)

LED Fahrenheit degree if it is lit, the unit of measure of the temperatures

will be Fahrenheit degree (parameter Uni)

The keyboard and/or the working setpoint are locked; look at chapter 2

View of the excluded device

Press and hold "set" for 4 seconds.

The temperature controller is turned on or off.

The temperature controller is turned on or off

Need help?

Do you have a question about the Evco 470.778 and is the answer not in the manual?

Page 1 INSTRUCTION MANUAL Thermostat EVCO Part no.: 470.778 Signals of the instrument LED load, if it is lit, the load will be turned on. If it flashes: - the modification of the working setpoint will be running - a load protection will be running (parameters C1 and C2) LED defrost if it is lit, the defrost will be running LED alarm...
Page 2 Locking/unlocking the buttons Press and hold “set” and “down” simultaneously for 2 seconds. Loc will be shown on the display for 1 second. Press and hold “set” and “down” simultaneously for 2 seconds. Unl will be shown on the display for 1 second. Display the set point Briefly press “set”...
Page 3 Changing from celsius to fahrenheit Briefly press “set” button. Briefly press “up” or “down” buttons to select “Uni” Select the menu item using “set” Change the units from 0 to 1 using “up” or “down” arrows. 0 - Celsius 1 - Fahrenheit Confirm selected value with “set”...
Page 4 Restoring the factory settings Press and hold “set” and “up” simultaneously for 8 seconds until dEF flashes on the display The reset is complete IMPORTANT! In the event of a fault, the factory settings should be restored first. Technical modifications excepted! Last revised: 03 / 2012...