Table of Contents
Advertisement
CONFIGURATION
Select the
CONFIGURATION
tab to view the current
settings for:
SSID
(Service Set Identifier)
is a name that
identifies a wireless
network. Access
Points and wireless
clients attempting to
connect to a specific
WLAN (Wireless
Local Area Network)
must use the same
SSID. The default
setting is default.
To perform an
Note:
automatic search of
available wireless
network, change the
SSID setting to Auto
Detect.
Network Type
Use Infrastructure
mode if you will be
using an Access Point
in your network.
Use Ad-Hoc, if you
will not be using an
Access Point. Ad-hoc
requires the same
channel and the same
SSID for wireless
devices on the
network.
802.11 Ad-hoc
requires the same
channel and SSID
among the wireless
clients.
Power Save Mode
– The Power Save mode is
used to extend battery life.
Note: In Power Save mode, the Access Points
used must support Power Saving for
communication to be established.
Tx Rate
(Transmission rate) – The default
transfer rate is Auto which allows the DCF-
660W to adjust to the most optimal transfer
rate available. However, the settings can be
s
et at a fixed transfer rate.
NOTE: Click Apply to save any changes.
Advertisement
Table of Contents
