Advertisement
AUSTRALIAN MADE
POOL & SPA PUMPS
INSTALLATION AND OPERATION MANUAL
GEN3 SERIES
GEN3-75, GEN3-100, GEN3-125, GEN3-150, GEN3-200
Reltech Australia Pty Ltd
43-45 Kylta Rd, West Heidelberg, Vic 3081
Ph: (03) 9459 3838
Fax: (03) 9459 4038
Em:
office@reltech.com.au
Web:
www.reltech.com.au
Page 1 of 9
Advertisement
Table of Contents
Related Manuals for Reltech GEN3 Series
Summary of Contents for Reltech GEN3 Series
- Page 1 AUSTRALIAN MADE POOL & SPA PUMPS INSTALLATION AND OPERATION MANUAL GEN3 SERIES GEN3-75, GEN3-100, GEN3-125, GEN3-150, GEN3-200 Reltech Australia Pty Ltd 43-45 Kylta Rd, West Heidelberg, Vic 3081 Ph: (03) 9459 3838 Fax: (03) 9459 4038 office@reltech.com.au Web: www.reltech.com.au Page 1 of 9...
- Page 2 ➢ The fittings on this product are constructed of ABS. Some PVC jointing compounds are incompatible with ABS. Check compound suitability before use. ➢ RELTECH recommends that all installations are fitted with earth leakage or residual current protection devices. ➢...
-
Page 3: Features And Benefits
RELTECH’S advanced pump technology provides reliable and efficient performance that lasts. RELTECH pool and spa pump are designed with high flow and the head pressures are ideally suited for the modern pool or spa with extensive equipment. - Page 4 Power Connection RELTECH pool and spa pumps are suitable for connection to a nominal 240-volt 50Hz power supply. The motor is equipped with a flex and 3-pin plug. If a power outlet is not available within 2 meters of the pump, a 3-pin power point in a safe, dry place may need to be provided by an electrician.
-
Page 5: Pipe Connection
Pipe Connection A barrel union is provided for connecting to the piping from the pool. The pumps are designed to accept the following PVC Pipes: • Inlet PVC Position 40mm pipe ID or 50mm fitting ID PVC pressure pipe fittings •... - Page 6 Pump operation For optimum pump performance, the strainer basket housing should always be full of water and free from air bubbles. The water level of the pool should always be maintained to at least halfway up the skimmer box ensuring water is in the pump at all times. From time to time, it may be necessary to re-prime the pump.
- Page 7 ➢ Barrel unions need to be hand tightened. No sealant, glues or silicones are required. ➢ When making any enquiries about your RELTECH pool and spa pump be certain to quote the model number from the nameplate located on motor.
- Page 8 7 days of the recognised fault. Reltech will at its option, repair or replace any defective parts. Component failure must be due solely to a defect in materials or workmanship. This warranty does not apply if failure is due to any abuse, misuse, improper installation or accident or to any of the following: •...
- Page 9 PLEASE NOTE: ➢ This literature is not a complete guide to product usage. Further information is available from your RELTECH dealer, RELTECH Customer Service Centre and from the relevant product Installation and Operating Instructions. ➢ This data sheet must be read in conjunction with the relevant product Installation and Operating Instructions and all applicable statutory requirements.
Need help?
Do you have a question about the GEN3 Series and is the answer not in the manual?
Questions and answers