Yamaha RX-V371BL Quick Reference Manual page 7

4
Connect the YPAO microphone to the YPAO MIC jack on the front panel.
"MIC ON. YPAO START" appears on the front panel display, and then changes to display the following.
This completes preparations. To achieve more accurate results, be careful of the following when
measuring.
• Measuring will take approximately three minutes. Keep the room as quiet as possible during
measurement.
• Wait in the corner of the listening room during measurement or leave it entirely, to avoid
becoming an obstruction between the speakers and the YPAO microphone.
5
Press SETUP on the remote control to start measurement.
The following display appears if measurement fi nishes without any problems.
Note
When a problem occurs, an error message or a warning message appears either during or
after measurement. Refer to "Set up the speaker parameters automatically (YPAO)" in Owner's
Manual to solve the problem, and carry out YPAO again.
6
Press ENTER on the remote control to apply the results of measurement.
7
Remove the YPAO microphone.
YPAO fi nishes automatically when the YPAO microphone is removed.
YPAO
VOL.
Press [SETUP]
Progress
YPAO
VOL.
Progress 00%
YPAO
VOL.
YPAO Complete
YPAO
VOL.
Disconnect MIC
YPAO microphone
SW
C
L R
SL SR
SW
C
L R
SL SR
SW
C
L R
SL SR
SW
C
L R
SL SR
- 7 -
RECEIVER A
DOCK DOCK
SETUP
ENTER