Advertisement
Quick Links
Santa's Advent Robot
Day 24
Keypad / Controller
Today you get to fit the final part, a keypad which you can use to control and program your robot. To
fit it, place it over the 4 pillars you fitted yesterday and push it down into the black connectors. You
will need to have removed the side cables. Screw the keypad into place using the 4 screws provided,
then refit the side cables. See next page for programming instructions.
Advertisement
Related Manuals for 4tronix Santa's Advent Robot
Summary of Contents for 4tronix Santa's Advent Robot
- Page 1 Santa’s Advent Robot Day 24 Keypad / Controller Today you get to fit the final part, a keypad which you can use to control and program your robot. To fit it, place it over the 4 pillars you fitted yesterday and push it down into the black connectors. You will need to have removed the side cables.
- Page 2 Santa’s Advent Robot Day 24 Programming Santa’s Sleigh Using these instructions, you can program Santa’s Sleigh to go and fetch your presents and bring them back to you! If you have ever programmed a Bee-Bot then you’ll be able to do this as well. The Keypad has three groups of buttons: 1.
- Page 3 Santa’s Advent Robot Day 24 Command Buttons Clear: This Clears the sequence and removes all movement commands allowing you to start a new program/sequence Demo: This will cycle through the various Demonstration programs that are available, shining a different colour to indicate which demo is selected Red: The standard demo you have been using up until now (square, octagon, square, etc,) •...
Need help?
Do you have a question about the Santa's Advent Robot and is the answer not in the manual?
Questions and answers