Supplied Accessories - Yamaha PDX-31 Owner's Manual

Portable player dock

Hide thumbs Also See for PDX-31:

Owner's manual (23 pages)

Owner's manual (51 pages)

page of 4

/ 4
Bookmarks

Enlarged version

INTRODUCTION

Symbols Used in this Document

■

•

: indicates a tip for your operation.

•

: contain important information about safety and

N o t e

operating instructions.

Supplied Accessories

■

Please confirm that the following accessories are included

before using the unit.

The identifiers "

" shown here refer to the identifiers

used in the Quick Manual. Refer to the Quick Manual.

Remote control [

] ...............................................................

AC adaptor [

] .....................................................................

Power cable [

] ....................................................................

No t e

Connect the AC adaptor and power cable to the unit before

connecting the power cable to a wall outlet.

Owner's Manual (this manual) ...............................................

Quick Manual .........................................................................

CONTROLS AND OPERATIONS

The identifiers (

, etc.) shown here refer to the identifiers used in the Quick Manual. Refer to the Quick Manual.

iPod Dock

Connects an iPhone/iPod to the unit. When the iPhone/iPod is connected, the unit turns on and begins charging the iPhone/iPod's

battery.

To listen to music through the unit's speakers, begin playback on the iPhone/iPod.

The iPhone/iPod can be connected or disconnected anytime. When the iPhone/iPod is disconnected from the unit, the unit

remembers the volume level. When the iPhone/iPod is connected again, the volume is set at the same level.

N o t e s

•

Be sure to use a Dock adapter that is compatible with your iPhone/iPod.

•

If you do not use an adapter or if the adapter is not compatible, the connection could be loose or poor, which could cause

damage or malfunctions.

•

The iPhone/iPod may not be set in the iPod dock securely if it is in its protective case.

AUX

Connects an external device to the unit. When the external device is connected, the unit turns on.

To listen to music through the unit's speakers, begin playback on the external device.

To connect an external device to the unit, use a commercially available 3.5 mm (1/8 in) stereo mini plug cable.

No t e

When disconnecting the external device, be sure to remove the cable from AUX. Otherwise, the unit will remain on while the

cable is connected.

(Volume keys)

Adjust the volume level.

•

If the volume was set at a high level when the iPhone/iPod or external device was disconnected, the volume may be lowered

automatically when playback begins.

•

When the AC adaptor is disconnected, the volume level will be reset to the default volume level.

15V

(AC Adaptor)

Connects the AC adaptor to the unit.

Status Indicators (LEDs)

Indicate the status of the unit and a connected iPhone/iPod. The status of a connected external device is not indicated.

•

Green status indicator: The unit is turned on and operating normally.

•

Red status indicator: An error has occurred or the volume has reached its maximum or minimum level.

LED

Green

Red

An iPhone/iPod is connected.

The volume level has been adjusted using the iPhone/iPod or unit's volume keys, or a

signal has been received from the remote control.

Once

Connection in progress, please wait.

Continuously

30 seconds have passed since the iPhone/iPod was paused.

The unit's volume has reached the maximum or minimum level when an iPhone/iPod is

connected to the iPod Dock.

Once

The unit's volume has reached the maximum or minimum level when an external device is

connected to AUX.

Once

The connected iPod is not supported.

Refer to "TROUBLESHOOTING" for the proper remedy.

2 sec.

Connection failed.

Refer to "TROUBLESHOOTING" for the proper remedy.

Continuously

An error occurred and the unit's protection circuitry has been activated.

Refer to "TROUBLESHOOTING" for the proper remedy.

Continuously

...Lit

...Flashing

...Off

Replacing the Remote Control Battery

When It Is Exhausted

While pushing

the release tab in

direction A, slide out

the battery holder in

direction B.

Back

Battery

CR2025

Status

AVAILAbLE OPERATIONS

The operations that can be controlled for the connected iPhone/iPod and external device are indicated by

available).

Connected device

iPhone/iPod

Operated device

Volume Control

The Unit

iPhone/iPod

External Device

Remote Control

When an iPhone/iPod and external device are connected and playing at the same time, the volume levels of both the iPhone/iPod

and external device will be adjusted.

To adjust the volume level of the external device independently when an iPhone/iPod and external device are connected and

playing at the same time, adjust the volume level at the external device.

For information about using the remote control, refer to the Quick Manual.

TROUbLESHOOTINg

Refer to the table below if the unit does not operate properly. If the problem you are experiencing is not listed below, or if the

instruction below does not help, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service center.

Problem

No sound.

The iPhone/iPod is not connected

securely.

The external device is not connected

securely.

The unit is not turned on.

The volume is turned down.

The protection circuitry has been

activated by excessive volume.

Cannot change the unit's volume

The connected iPod is not supported,

by changing the iPhone/iPod's

or the iPhone/iPod is not connected

volume.

securely.

The iPhone/iPod display does not

change by pressing the remote

control's volume keys.

The iPhone/iPod cannot be

controlled using the remote

control.

The external device cannot be

When playing an external device, only

controlled using the remote

the volume can be changed using the

control.

remote control.

The remote control cannot be

The remote control is out of operation

used.

range.

The battery is exhausted or was not

inserted correctly.

The insulation sheet has not been

removed.

The green status indicator is lit,

Connection failed.

and the red status indicator is

flashing.

The green status indicator is off,

An error occurred and the unit's

and the red status indicator is

protection circuitry has been activated.

flashing continuously.

SPECIFICATIONS

Supported iPhone ...................................................................................................................................iPhone, iPhone 3G, iPhone 3GS

Supported iPod ..............................................................................................iPod (5th generation), iPod classic, iPod nano, iPod touch

AUX input connector ....................................................................................................STEREO L/R: 3.5 mm (1/8 in) stereo mini jack

Maximum output power per channel (6 Ω 1 kHz, 10% THD) ........................................................................................... 15 W + 15 W

Power supply

U.S.A. and Canada models. ...................................................................................................................................AC 120 V, 60 Hz

Other models ......................................................................................................................................... AC 100 to 240 V, 50/60 Hz

Power consumption .......................................................................................................................................................................... 10 W

Power consumption without connecting iPhone/iPod or external device ........................................................................ less than 0.5 W

AC adaptor .................................................................................................................................... NU40-8150266-I3 (DC 15 V, 2.66 A)

Dimensions (W

H) .....................................................................................................................................350

Weight (without accessories) ............................................................................................................................................1.7 kg (3.7 lbs)

* To play an unsupported iPod, such as a 4th generation (or earlier) iPod, iPod shuffle, iPod photo, and iPod mini, connect the iPod

to AUX and use it as an external device.

* Specifications are subject to change without notice.

(available) or

External Device

Other Operations

Volume Control

Other Operations

Cause

Remedy

Connect the iPhone/iPod securely.

Connect the 3.5 mm (1/8 in) stereo