Light Replacement; Power Failure; Moving The Cooler; Drip Pan - IDW G-2 Instruction Manual

Light Replacement

•
Unplug the cooler before removing the light.
•
Remove the screw.
•
Remove the light cover gently.
• Remove the light.
• Replace the light with the equivalent fluorescent bulb.
• Install the light cover and tighten the screw.

Power Failure

•
Please minimize the frequency of opening the door during a power failure.
•
If your cooler is unused for an extended period of time, unplug, empty, and clean your cooler.
Keep the door open to avoid condensation, formation of molds, or odors.

Moving the cooler

•
Empty the unit.
•
Secure all loose parts inside the cooler.
•
Tape the door shut.
•
During transportation, make sure that the cooler is in an upright position.

Drip Pan

•
During normal compressor cycle, water will drain into the drain pan and evaporate.
•
To clean, pull the drain pan forward gently and reinstall it after cleaning.
5