Page 1
User Manual 415U-E-BSR Base Station Repeater Effective June 2021 415U-E-BSR Base Station Repeater Version 1.1 www.elpro.com.au...
Page 2
GNU Free Documentation License: ATTENTION Copyright (C) 2009 ELPRO Technologies. ELPRO Technologies is using a part of Free Software code under the INCORRECT TERMINATION OF SUPPLY WIRES MAY CAUSE INTERNAL GNU General Public License in operating the 415U-E-BSR product. DAMAGE AND WILL VOID THE WARRANTY. TO ENSURE THAT YOUR 415U-E-...
Example 3 – Both Repeaters Primary ............ 8 Example 4 – Both Repeaters Primary ............ 8 Maintenance..................8 Firmware Update ................8 Fuse ....................8 Dust Filters ..................8 Appendix A – Specifications ..............9 Appendix B – GNU General Public License ........10 www.elpro.com.au...
The 415U-E-BSR Base Station Repeater Provides a redundant Base possible, remote device will connect through the repeater that is Station and Repeater for ELPRO 450U-E, 415U-E and 415U-2 Remote acting in primary mode. If the repeater operating as primary fails or radio modules.
We from Lightning damage. Surge arrestors should have a turn-on recommend that the connection be taped—first with a layer of voltage of 90V. Recommended part ELPRO CSD-N-6000. PVC tape, next with vulcanizing tape (such as 3M™ 23 tape), •...
The Soft Fault status indicated by the Status LED turning Orange indicates when this is not the case. The Soft Fault meaning depends on whether the repeater is operating as primary or secondary. www.elpro.com ELPRO...
If this is the first time you have used your computer to connect to an Radio Setup page. ELPRO device through the USB port, then you will need to install the USB driver file from the product’s internet website. This is available from the same location that you downloaded this user manual.
The repeater responds with a username and password box. normally be “Local Area Connection”. For the USB port, this will be “ELPRO 415U-E USB Ethernet/RNDIS” Type the username and password. The default username is “user” and the default password is “user”.
Refer to Figure 9 - Remote to help understand the state of the system. Web Page Diagnostics Web-page diagnostics are accessible through a web browser from the repeaters’ main pages. Refer to section “Main Configuration www.elpro.com ELPRO...
High byte of register 30405 Least Significant Low byte of register Byte 30405 30407 – 30408 Radio Transmit Frequency (in Hz). 32-bit. Most significant word at lower (odd) address. 30409 – 30410 Radio Receive Frequency (Same as Transmit Frequency) www.elpro.com ELPRO...
Check that the remote master correctly If your 415U-E-BSR is installed in a dusty environment, you should manages the local mode control switch – see “Using Fail-Safe on loss increase your cleaning schedule to monthly. www.elpro.com ELPRO...
Base station, Repeater, Remote for large fixed and parameters roaming station networks, redundant radio paths, Weight 5.5kg (Product Only) automatic selection of radio paths, prioritization of 7.0kg (Packaged) traffic flows, bandwidth efficiency features, bandwidth utilization, routing, bridging, VLAN User configuration Network access: Ethernet www.elpro.com ELPRO...
3. You may copy and distribute the Program (or a work based on it, under Section 2) in object code or executable form under the terms of Sections 1 and 2 above provided that you also do one of the following: www.elpro.com ELPRO...
Page 14
RENDERED INACCURATE OR LOSSES SUSTAINED BY YOU OR THIRD PARTIES OR A FAILURE OF THE PROGRAM TO OPERATE WITH ANY OTHER PROGRAMS), EVEN IF SUCH HOLDER OR OTHER PARTY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. www.elpro.com ELPRO...
Need help?
Do you have a question about the CONDOR Series and is the answer not in the manual?
Questions and answers