Subscribe to Our Youtube Channel
Related Manuals for Dolphin BC200SCH-SM
Summary of Contents for Dolphin BC200SCH-SM
- Page 1 BC200SCH-SM DOLPHIN HORIZONTAL SURFACE MOUNTED BABY CHANGING UNITS I N S TA L L AT I O N M A N U A L February 2024...
-
Page 2: Before You Begin
Any operations performed on the changing station must be compliant with the safety laws and regulations, both European and local, that are in force at the time. Dolphin Solutions is not liable for damages caused by the improper installation, poor maintenance or misuse of this baby changing station. -
Page 3: Installation Instructions
Four blunt Philips screws (DIN7985 A2 M4x8 mm) to fasten the liner dispenser to the metal wall structure Four flat washers (DIN125 M4 A2) to be mounted with four blunt Philips screws (M4x8 mm) to fasten the liner dispenser | Dolphin Solutions | 3 BC200SCH-SM... - Page 4 228 mm on either side of the chassis for fixing the changing station to the wall and 570 mm of the changing station bed, when it is open, from the wall. 4 | Dolphin Solutions | BC200SCH-SM...
- Page 5 Installation according to ADA regulations. If it is required that the installation complies with the ADA regulations (USA), the installation should be made taking into account the following installation dimensions. | Dolphin Solutions | 5 BC200SCH-SM...
- Page 6 Put the changing station back on the top two screws and fix the structure to the wall with the four Ø6.3x70 mm screws and the four DIN125 M8 washers of the lower holes, then fully tighten the top two screws, the distribution of the components is shown in the following figure: 6 | Dolphin Solutions | BC200SCH-SM...
- Page 7 Due to the problems posed by installations on this type of walls, with regard to fixing, it is recommended that the installation is carried out by technicians specialized in installations on this type of walls. Dolphin Solutions is not responsible for the installation of its changing stations on plasterboard or hollow walls.
- Page 8 In summary, it is very important to verify, once the installation of the baby changing station is complete, that it is in perfect condition to be used without any problems. 8 | Dolphin Solutions | BC200SCH-SM...
- Page 9 Remember that any additional component or spare par t required for the baby changing station should only be purchased from the manufacturer or an authorized distributor. COMPONENT Label Shock absorber BC200SCH-SM / BC200SCH-R Lock + key Protective liners Shock absorber BC200SCH-SM / BC200SCH-R...
- Page 10 4 fixing screws are tightened with their respective washers. › Inspect the label: if it is missing, damaged, illegible or not properly attached, a new one should be placed. 10 | Dolphin Solutions | BC200SCH-SM...
- Page 11 Clean all plastic pieces of the changing station using antibacterial soap. › On the BC200SCH-SM / BC200SCH-R model, avoid contacting the stainless steel front with the antibacterial soap; it has to be cleaned with a standard stainless steel cleaner and a soft cloth.
- Page 12 Dolphin Solutions Ltd Southpoint, Compass Park, Bodiam, Robertsbridge,TN32 5BS Tel: +44 (0)1424 20 22 24 Fax: +44 (0)1424 205 200 info@dolphinsolutions.co.uk www.dolphinsolutions.co.uk...
Need help?
Do you have a question about the BC200SCH-SM and is the answer not in the manual?
Questions and answers