Page 1
Precision Group 5920 S 194th Street Kent, WA 98032 Technical Support: 253-872-1910 ELECTRONIC WEIGHING KIT OPERATING and MAINTENANCE MANUAL REVERE Neptune Gen 1 Doc. 155800...
AN spherical jack pad. An electrical receptacle For the purpose of mounting the ADAPTERS: cells under varying physic a l ar:;:-angements, the is located on the side of the cell ta plug in the SO-foot cable which connects the cell and the hl. follow:Lllg adapters are provided: plug and ring ci.ic ator- amplifier.
Page 4
OPERATL"'!G L"'!STRUCTIONS f . · PRE-OPERATIONAL PROCEDURE: later described and place a partial load on each cell. A stabilizing period of 20 minu te s '":11;.ce: the Kit in any con-1-enien.t location within running cone urre!:1.tly with warm up p eriod is _he len.gth the 50-foot cell cables.
Page 7
Trouble Probable Gaus.e f Remedy Capacitance change Sensitivity bad on one (or two) Adjus.t phasing capacitor G-3, C-4 in cell-cable circuit cell(s). Place counter at zero or C-5. causing out phas- and adjust appropriate zero po- tentiometer until meter pointer io.g between ampl_ i - is just touching right-hand side fier and cell-cable...
Page 8
Trouble Probable Gal!.se Remed y Jump y cell bala!!.ce needle on 0 scillator-a.mplifier Return kit factory. all cells. ( c onti.nued) phasing is bad. Power pack filter Check power pack components, faulty. C-201, C-202, etc. Cell balance meter pegs as Short occurs some- Secure wires properly on te?'mi.n- amplifier cove:- is secured..
Need help?
Do you have a question about the REVERE Neptune Gen 1 and is the answer not in the manual?
Questions and answers