Venset Fitting set B. 813 Instructions For Fitting

Instruction for Fitting set B.
Article no.: 813
Please read the enclosed instructions for use and assembly before installation and use.
Contents:
1. Advice on security and warnings
2. Guidelines for use
3. Installation
1. Advice on security and warnings.
This product complies with all prescribed security regulations. Inappropriate use can cause damage to users and product.
•
VenSet cannot be held responsible for any damage on the window or other parts of the building, whether it is caused by ordinary use,
•
wrong installation, unauthorized maintenance or incorrect use.
Please read the instruction before using the window the first time. It will give you important directions as to security, use and installation
•
of the window opener, and thus prevent any damage on both you and the product.
This product may not be used on windows functioning as emergency exits.
•
Please keep this instruction hereafter.
•
2. Guidelines for use.
This Fitting set B article no. 813 has been designed to be used together with VenSet electrical window opener article no. 110, when this is
•
to be installed in windows with a sill measuring less than 50 mm.
This instruction must be used together with the instruction: vejl_110_060101.doc.
•
•
Point 3 conc. Installation in this instruction replaces point 3 in the instruction: vej_110_060101.doc for VenSet electrical window opener
•
article no. 110.
Fitting sest B is to be used together with standard sill fittings, which are delivered with the electrical window opener.
•
3. Installation
Risk of bodily harm. Be careful that the window does not suddenly open or close uncontrollably during the installation of the fitting/
•
window opener.
The VenSet window opener replaces the ordinary operating and locking devices of the window. Before the installation of the window
•
opener on the enclosed fittings, the window must be opened, and the ordinary operating and locking devices of the window must be
removed.
Sill measurements between 0 and 30 mm:
Installation of L-fitting.
Install the L-fitting so that it levels with the sill. If there is no sill to level with,
you can open the window.
Installation of sill plate.
Install the sill plate on the L-fitting, so that the exterior edge of the sill plate is 53
mm from the frame.
Use the oblong fitting holes and the enclosed screws and nuts. The width of your
sill will determine, whether you should use the inner oblong holes or the outer
ones.
Copyright 2005, VenSet A/S, VenSet
®
is a registered trademark
1/3
Side