Salus KL04RF 24V Manual

Wiring centre extension for KL08RF 24V
Model: KL04RF 24V
Manual
PRODUCER:
Salus Limited
6/F, Building 20E, Phase 3, Hong Kong
Science Park, 20 Science Park East Avenue,
Shatin,
New Territories, Hong Kong
www.saluscontrols.com
SALUS Controls is a member of the Computime Group.
Maintaining a policy of continuous product development SALUS Controls plc reserve the right
to change specification, design and materials of products listed in this brochure without prior notice.
Wiring Centre Description
1. Serial Connector + power supply from the main wiring centre
2. Connection diode
Introduction
The KL04RF 24V module is an extension to the KL08RF 24V wiring centre for an additional 4 heating
zones. Works only in combination with KL08RF 24V wiring centre and increases its functionality up to
12 individual heating zones.
Product Compliance
This product complies with the essential requirements and other relevant provisions of the following
EU Directives: EMC 2014/30/EU, Low Voltage Directive LVD 2014/35/EU, Radio directive 2014/53/EU
and RoHS directive 2011/65/EU. The full text of the EU Declaration of Conformity is available at the
following internet address: www.saluslegal.com
Safety Informations
Use in accordance with national and EU regulations. Device is intended for indoor use only in dry
conditions. Product for indoor use only. Installation must be carried out by a qualified person in
accordance to national and EU regulations.
Before attempting to setup and install, make sure that KL04RF 24V is not connected to any power source.
Installation must be carried out by a qualified person. Incorrect installation may cause damage to the
wiring centre. The KL04RF 24V should not be installed in areas where it may be exposed to water or
damp conditions.
Technical Information
Power Supply From KL08RF 24V wiring centre
Max load 3 A
Outputs 24 V AC
Dimensions [mm] 163 x 85 x 67
3. Work status indication of each zone
4. Output terminals for actuators
1 2
9
10
KL04RF 24V
1. Serial connector
It is used for communication between KL08RF 24V wiring centre and KL04RF 24V extension module.
Combined set increases support up to 12 zones.
2. Power supply
3
11 12
4
9 10 11 12
KL04RF 24V
The KL04RF 24V extension module is powered via the serial
connector that connects the module to the KL08RF 24V wiring
centre. For the wiring centre KL08RF 24V with the KL04RF 24V
extension module, you can choose up to 12 actuators (use 24V
actuators).
9 10 11 12
KL04RF 24V