Table of Contents Introduction ..........................3 What is HP0A..........................3 Specifications ..........................3 Features ............................3 Block Diagram ..........................4 How to use ..........................5 Get IP Address ..........................5 SSH Access for Linux console ...................... 5 Location of global_conf.json file....................5 Location of Semtech packet forwarder.
1 Introduction What is HP0A The HP0A is a full hotspot for Helium. User can connect their sensors to Helium network via HP0A. Specifications Hardware System: Linux Part: Interface: 10M/100M RJ45 Ports x 1 LoRaWAN Wireless ...
2 How to use Get IP Address Connect the HP0D Ethernet port to your router and HP0D will obtain an IP address from your router. In the router’s management portal, you should be able to find what IP address the router has assigned to the HP0D.
User need to connect antenna cable’s SMA connector to the HP03 and connect N-Type connector to antenna and install as below: 3 Manufacturer Info Shenzhen Dragino Technology Development co. LTD Room 202, Block B, BCT Incubation Bases (BaoChengTai), No.8 CaiYunRoad LongCheng Street, LongGang District ; Shenzhen 518116,China...
4 FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the HP0DA and is the answer not in the manual?
Questions and answers