Avsl lyyt 153.806UK User Manual

DIY COB Tape Kit
Thank you for purchasing the Lyyt DIY COB Tape Kit. LED tape is ideal for use on the underside of a
counter tops, shelves, cupboards, around window frames or in an alcove of a ceiling to name just a few
examples.
Before starting, please ensure that you have read this instruction leaflet carefully. If you are unsure about
any of the installation details, please consult a professional.
Kit Contents:
• 5m COB LED Tape
• UK Power supply
• Solder free connector
Preparation
Ensure that the surface you are attaching to is clear of dust and dirt. Clean thoroughly and leave to
dry before fitting the tape. Unravel the tape and connect the power supply. Check that all the LEDs
are functioning correctly and if there are any faults return to your retailer without delay.
Cutting
WARNING: Disconnect from the power supply before attempting any cutting.
Measure out each section and cut with sharp scissors at the marked 50mm intervals to achieve the
perfect length. Do not discard any excess tape as it can be easily reconnected and used again.
Fitting
Clear the area you wish to install the tape and remove the backing paper, exposing the adhesive.
Push tape firmly onto the surface. It is recommended to work on 50mm sections at a time to ensure
a professional finish. When you reach the end of your installation cut at the marked cutting point.
Item ref: 153.806UK / 153.807UK / 153.808UK
User Manual